Any One able to help me Singer xl100 does anyone have embroidery hoops or cards for one of these

First turn off the XL-1000 and remove the auxilliary bed. Attach the embroidery bed and push the lever on the front of the bed to the right. Switch to the embroidery presser foot. Thread the machine with the appropriate embroidery thread and bobbin thread. Set up the embroidery hoop. Turn on the machine. Lift the presser foot to the highest position. Slide the embroidery hoop under the presser foot such that the key on the hoop goes into the slot on the embroidery bed.

The directions for setting up the hoop are given in the manual for the Quantum XL-1000. Singer has most of their manuals here: https://www.singer.com/support .The current link to the manual is https://www.singer.com/sites/default/files/product_manual/1259_xl-100_0.pdf . The section on embroidery starts on page 54 (page 56 of the PDF). Page 57 has the information on securing the hoop to the embroidery frame.

I hope this helps.

Cindy Wells

The switch for "sew" or "embroidery" must first be in the "embroidery" position.
Make sure the connections are very firmly pushed in.
If it still isn't functional it may require some small motors to be replaced. The motors are what makes the hoop move.

Sounds like the card is the problem.

Send a picture of what you would like and I would tell you the difficulty and anything else I may need. What format does it use if you know.

[email protected]

http://www.ebay.com/itm/like/380994188253?lpid=82 and try searching for other in there as well....:)

Try push in and push out your hoop several times into the carriage, then if the problem is still there, most likely the carriage hoop lock sensor is faulty.

I just looked at what you wrote, ok machine embroidery now we are talking , you know you have to hoop it.. dont you, you also need a special embroidery foot and the feed dogs need to go down have a look at your manual for a start can they go down? than to start learn to hold the hoop as remember you decide how large and small the stitches are for your design look at you tube.. ok? you will find me in most embroidery groups but I have specialised machines.

You will need a converter box that hooks up to a computer and writes to a card that fits into your sewing machine. Singer PSW 1,0 (box and card), OESD Magic Box (4 slot), and Amazing Designs Amazing box (also 4 slot) will do this. You will also have to make sure these boxes come with a blank card. Amazing Designs and OESD cards MAY be interchangeable. Not sure about the Singer card. In regards to the Singer Card--there are 2 types. Make sure the one you get is for the XL100 or XL1000. XL5000 on up is different. Singer, OESD, or Amazing Designs no longer support Singer XL100 so you will have to go to EBAY. These items are rare but they do pop up a few times a year. ALSO, the software only runs on Windows XP. Don't know if there is a patch, but there is a Yahoo group that deals with Singer XL100/1000. Good Luck

First is this a hoop that came with it or is it a fits all hoop? if you havent' used this manchine alot for this the hoop my be hard to push down hold the front of the hoop up and push the back down into the slots as you use it it will get easier.

well P it sounds like your hoop might be bent or at least the pins that go into the arm see if you can bend them out a bit also does this happien with all sizes of hoops?
Also for the Guest make sure that your needle isn't bent better yet just change the needle also take your bobbin out and flip it the other way and see if it still comes through hope this helps you guys