Dgs-200 Problems after time out delay the camra goes to E0001 or E0002,E0003,E0004,E0430 I have seen several different codes but some times it still takes pic's. Last weekend when it got dark it started taking pic's every 60 seconds. but when I looked through the pic's it only showed around 20 pic's and I was in my tri pod watching it and it had to have flashed 100 times. any ideas

Check flash is not obscured by the case
Check AF is set to infinity or [set by range]
Ensure target is within AF zone...might be aiming too low in order for it to register movement.

remove batt for a few minutes then reinstall

just clear error using additional * then (2+8 same time) again * after this process in screen displays copier select then function in function menu clear in clear menu select all option one by one and press ok after each selection and restart ur machine....

if problem continues replace the thermistor in the heater section

There are 3 step to repair e0002 error

If you got e0002 error then there is a 94% chance that your computer has registry problems. To repair e0002 error you need to follow the steps below:

* Step 1 - Download a e0002 error repair tool,install this error repair tool.
* Step 2 - Click the Repair All Button.It will scan you pc for Free.
* Step 3 - Then click the Repair All Button again and your done! It is very easy to repair e0002 error.

Here are the url of e0002 error repair tool:
http://www.fixerroreasy.com/ttfix-e0002_error-zz0005

here's your manual:
http://images.ebsco.com/pob/Moultrie/catalog/DGS-200Instructions.pdf

replace the LCD...free from www.moultriefeeders.com

Have you done the time/date setup? Online manual says it goes auto after 4 minutes, but perhaps the date/time need to be setup first? Online manual here in case you lost your book :)

http://images.ebsco.com/pob/moultrie/catalog/dgs-i40-user-manual-compressed.pdf

be patient, it takes a bit to load

I had this same camera 3 different times! I would get all kinds of crazy error codes I could never fix. My best advice is to send it back if still under warranty and they will replace it like they did mine 3 times.

I have the same problem with my camera. I contacted Moutrie about the problem and I was told that the capacitor for the flash is not charging. I asked for moutrie to send me the capacitor so that I could replace it, but they do not send out parts for cameras. If the camera was bough within the last year, it has a 1 year warranty and moutrie will fix the camera.

I'm not able to erase the internal memory on my moultree trail camera. When it asks if I want to erase the memory I answer yes and it eventually says redo. I went through the diagnostic test and it identified error code 000400. I no longer have my owners manual and was hoping to go online to find the solution. Any help would be greatly appreciated.
lfp