How to change belt on shark navigator vacume - Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

That is nearly always caused by having the 's-twist' going the wrong way. When running it should be pulling the belt onto the spindle.

https://www.google.com/search?q=Shark+Navigator+replace+belt

..

This was stolen from the Internet:

Shark Navigator Lift Away Deluxe NV360 Roller Brush Belt Replacement

Anthony

Hello, this is Ava with Think Crucial.

If your the brushroll is not moving there could be several problems

Firstly, the motor may be the problem. If you hear any noises while the machine is running, you should contact the original manufacturer for troubleshooting solutions.

Secondly, your vacuum may be in need of new parts. By changing either the brush roll or belts, you should be able to increase the quality of the suction.

You can purchase a wide variety of high quality Shark replacement parts for your Shark vacuum direct from Think Crucial with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

http://www.thinkcrucial.com/search?type=product&q=shark

I hope this was helpful.

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

HI, it's Jim from Crucial Vacuum!

If your Shark Navigator vacuum is only making a strange noise when the brush roll is turning then the two things to consider and examine would be the brush roll itself as well as the belt.

First off lets look at the brush roll itself. Right off the bat is there any noticeable debris caught in it? You're mainly looking for long carpet fibers, or even strands of hair? If so try using a scissor to cut the blockage away. Then, manually rotate the brush roll to uncover further clogs. When examining your brush roll take note of the condition of the bristles. Are they loose? If so this would be a good time to change your brush roll entirely. There should be two screws holding the plate onto your Shark Navigator. Use a screw driver to remove these screws to gain access to the brush roll and belt.

The second part to check would be your Shark Navigator's belt. With use the belt will stretch out, lessening the tension on the brush roll. Lesser tension diminishes the brush roller's turn rate and speed. So if your belt feels loose as well replace that. A general rule would be that you're going to want to replace your belt about every 6 months. And if your belt is really loose this could be causing a noise when your brush roll is active.

You can purchase your replacement parts for your Shark Navigator direct from Crucial Vacuum with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

http://www.crucialvacuum.com/catalogsearch/result/?q=Shark+Navigator&limit=all

I hope this was helpful. If you would like further assistance, please feel free to give us a call at 877.750.9239. We have helpful and friendly customer care representatives on the line ready to assist you.

Jim Thompson
Crucial Vacuum Customer Care
http://www.crucialvacuum.com

Dear sir, This is the most likely cause of this problem: Be sure that the top tabs and the bottom lock clip are not damaged. (red arrows on photos of my own unit) These hold the filter in place. If damaged you may try several layers of super glue, or oder replacement part from shark.com parts for this model. good luck.

Call Shark cust. service. They should send you a new head

How do I change belt on shark navigator NV35627?

You don't. Call cust. service, they sound send a new head.

The SHARK website link below I think might be what you are looking for...

http://www.sharkclean.com/cgi-bin/livew/site.w?location=mcopy.w&mcopy=customerSupport&target=main&frames=no&sponsor=000006