Need replacement drip pans for ge xl44 gas stove

If it's gas they are manual control, only the oven has a thermostat.

If you are getting soot residue, it could be a number of things, First, is this a natural gas or propane oven? If you bought an oven to be used for propane, it may need to be converted from natural gas to propane or it will soot everything up. 2nd, have you recently spilled food/liquid onto the oven burner? If the burner holes are partially plugged, the remaining holes will burn large yellow flames and soot up the oven. Check the burner flames, they should be mostly blue with little to no yellow tips. Also make sure the oven burner flames are not too big. They should never exceed the width of the flame spreader pan directly above the burner, in fact they should be less than half the width. You could also have other issues like improper air shutter adjustment to the oven burner or very low regulator pressure, but most likely it has just been spilled on recently.

I have a GE Range Model JBS27W H2WW and the serial# XXXXX that I was cooking on and the back burner starting throwing out sparks and blew a hole in the coil and the drip pan. Now the light Burner on is staying on and I switched the 8 inch burner in the front with this 8 inch burner and still cannot get it to work.

Will any of these work?

http://www.repairclinic.com/Amana-Drip-Bowl-Drip-Pan-Parts

http://www.appliancepartspros.com/range-cooktop-oven-drip-pan.html

http://www.knobshopper.com/manufacturers/Amana-Replacement-Parts/cooktop_burner_drip_pans_bowls

It's really simple. Remove the burner grates, removed the old drip pans, then drop in the new drip pans. You can order a new drip pan from partselect.com if you don't have one yet. Let me know how this works out and if you need any further help.
Benjamin

I have a stove that doesn't light (click) I've replaced the igniters, I've replaced the knobs, and I've replace the box all the igniters and plugged into. There's nothing else to change out and it still doesn't give a spark. I've got gas and electricity but nothing will light

Send me an email and I can direct you to what we use and sell, [email protected].
Hope this helps!

water got into your switches..or one has gone bad. if water, let it sit a few days and dry out. turn off power.
if not, switch, under knob one of the 4 or 5 if you have 5...is faulty..needs replaced

Hi,
That is not that hard to fix and you can easily buy the parts yourselfonline...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

heatman101

My Jenn-Air had the same problem. When you install the drip pan for the burner module, there is a "finger" on the pan that is inserted into a hole in the front of the stove. If you look into that hole, you will see a lever switch. The finger on the drip pan on the burner module is supposed to push that lever switch down and turn the fan off, but over time the lever gets pushed down further and ultimately it does not get activated when the drip pan is installed.

You can either replace the lever switch, or you can try to pull it back into place and tighten the two small screws that hold it in place. Actually, I chose a third option and attached a small, flat spring to the finger on the drip pan.