Model wd52327, makes an repetitive grinding sound when turned on

best advice here to save money is to take it in have have the problem properly diagnosed and a quote
you can start replacing as you go but the end result is that it will cost as much as a new set with no guarantee of success
with a proper diagnosis of the problem you will have a good starting point for the fix

Starter clicking, not enough power to turn motor over. Check the battery, make sure charge is full. If it is, your starter is shot, replace it

Check and replace its color wheel. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" will make surf easy.
http://electronicshelponline.blogspot.com/

the grinding noise is from the cooling fan that cools the bulb. It needs to cleaned or replaced. You will need to take the back cover off the set to get at it. If the cooling fan is not doing its job that would cause the short bulb life and the noise

sounds like another bad hub brg, jack up front end and check for play in wheels from top to bottom wiggle for movement. A loose wheel brg will set a front speed sensor code.

Thats a very common problem which means that the capacitors on the power PWB have most likely failed. You can get the repair kit which has the replacement Capacitors and step by step instructions with detailed pictures on how to do the repair . Heres a link to the repair kit for your model.
http://servicemanuals.vstore.ca/product_info.php/pName/mitsubishi-v26-dlp-power-pwb-repair-kit/cName/repair-kits

Someone on here with the same problem mentioned that they shook the camera violently and it fixed the problem of it not focusing. I tried the same thing and actually gave it some light slaps on the tabletop. Well, now it works! I'm somewhat concerned that this fix won't last long.

Like many others' FE-230s, this camera began not focusing shortly after the one year warranty expired. I found my receipt and it turns out that I purchased the 2 year service plan at Best Buy and could get the camera replaced. But, now it works. Will it fail again after the 2 year plan expires? Jeez....

sounds like the light engine there are alot of problems with the light engines and quite a few have had a grinding noise. The only other possibility would be the color wheel. But I would lean heavier toward the light engine being the fault.

Hi.

Your problem is very lightly to be A faulty invertor pcb.
Relatively easy to replace but you may find it difficult to purchase.

The invertor pcb basically makes high voltage to strike up the tube lights behind the screen.

What make & model is your tv set & what country are you in.

http://dysonmanuals.llc.nu/

Chris..

Hi First I would check to see if the water may have been turned almost off under the sink, it will be the Hot water side. if that don't help then check for something plugging the line. let me know what you find, or we can go deeper krazytech