A Ø43 mm rubber gasket broke - where do I get a new?

We have no manuals. Sorry.

It sounds like you have a faulty gasket and to find if this is the problem you will have to find where they connect and look at the gasket/ or it might be a little round rubber ring. If you do find a broken rubber ring take it to your local hardware store and have them match it up and then just put it on and you should be all set or the easiest solution to this is store it empty and fill it when you are going to use it.

Hi,
Clean all debris from the sending unit area of the tank.
Use a large flathead screwdriver and a medium hammer to turn the retainer ring counter clockwise.
There are three tabs sticking up on the ring, hit each of them intermitantly, The ring will turn about 1/5 th of a turn then it will be fully free.
Reassemble it the same way, Make sure the new rubber gasket is the propper fit.
If its not the same, Use the old one.
Thanks.

Go to the hardware store and get a tube of plumber's grease. Then grease up the gaskets and the rubber ring. Snug everything down and if it leaks snug it down a bit more

Hi
If it is leaking on top of the machine and under the water tank, there is a seal that needs to be replaced. Lift off the water tank. There is a large gray doughnut cap that will pop off. Take a screw driver and slip it under the outside of the cap between the machines top and pry gently up and it will pop that side. Go to the other side and do the same. Set the cap aside and take you index finger and stick it in the center of the black gasket. Lift up and if the gasket comes out with it you need to replace it. Clean the inside of the receptacle before installing the new gasket.
Once you get the new gasket, slip it at a slight angle(flat side up), then take your finger nail and run it around the outside edge of the gasket. It will slip in, then push it down. Take the cover and snap it into place. Your good to go.

the little rubber gasket under the plastic cap is broken remove the plastic cp pull out the little white plastic piece flip it over remove the o ring and put in a new oen then put it back togeather.

what was it doing when the belt broke.... most times you just have the belt replaced and everything is fine.

Robert

did you see any rubber gasket on the ring.. this could be the one turn out to be loosen,

did you dropped or any kind of incident happened on the lens.

it has a fine ring clamp. find it and check it if its broke. they don't normally comes off easily. you will need a phillip screw driver to tighten it. unloosed it first, put the ring inside the gasket, then force the gasket gently to the metal round frame, then tighten the screw. i hope i was able to solve your problem. tnx