Toshiba c660 blansk screen no bootcreen - Toshiba satellite c660

Press and hold the 0 (zero) key on your keyboard and then press the computers power switch. When the computer turns on, the Toshiba HDD Recovery Utility screen will appear

this is how i did my partners c660

may also if its in bootable condition work by pressing f8 at startup then repair my pc then factory recover option

• Report abuse

just go to toshiba centre

Go into control panel and in the heading Appearance you will see an option for screen resolution. You can see in here how to change resolution, contrast etc
Hope this is some help

If it doesnt beep then you have a problem with your RAM or your motherboard. Try reseat your RAM first.

The lid has to come off. Make sure you remove the strip that is right above the keyboard so that you can get to the screws that hold the lcd in place. Also remove the screws on the bottom of the laptop that are right under the lcd screen. Sometimes there are screws on the back side of the lcd screen that have to be removed.

Toshiba Satellite C660 User Guide


Download Here

Check out this link @ http://za.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp?service=ZA

Make your selections for your download as below from the link above:-

Product type : Notebook
Family: Satellite
Product series: Satellite C Series
Model: Satellite: C660
Short Model No: PSC0SE
Operating system:...?...
Driver type: All
Country:...?...
Language: English

Hope it helps.

next to the F1 key and the windows key (2nd upper key and second to last key) are two screws, usually under some covering. unscrew and lift top edge of the keyboard towards the trackpad to lay face down. Undo the wire ribbon by lifting the grey or brown tabs and remove ribbon and keyboard. Then install the new keyboard by inserting the ribbon on the place. Lock down with the tabs and put the plastic prongs (close to the space bar) into the laptop body first, and then close keyboard onto the final position. screw back in and thats all. [email protected] for any additional questions.

press and hold fn and press f11.it sounds like you activated the sticky keys