Circuit board repair, need resistor detail of burnt one below top capacitor i.e. ohm ? going to replace burnt capacitors.
Gureja Tents is the most renowned tent house in Panipat who has been
decorating weddings and different events since 1964. Whether it's a birthday party, wedding
reception, corporate events or even a kitty party. You can directly
call Gureja Tents on 089500-79212 or visit http://gurejatents.com/ to know more.
SOURCE: I have a Bernina Sewing Machine with a Control Board that smoked
Bernina does not sell individual components for PCBs, rather they have an exchange program for the entire board. But you have nothing to lose and much money to save if you can obtain the parts and replace them yourself. You should be able to get the caps and resistors from any electronics supply.
Testimonial: "Terrific- that sorted that out as I could not easily find Bernina Service. I will go and buy the bits."
SOURCE: brother sewing machine circuit board is out need new one
If you have any problems with sewing machines with electronic boards or if the machine is computerised it is wise to take it to a specialist for repair.
SOURCE: viking sewing machine 940 needs spare parts
Certified Viking parts are only available from an authorized Husqvarna Viking dealer. However, there are some third party parts companies online. You should be able to find these using Google Search. However, I strongly recommend you have the machine serviced through an authorized Husqvarna Viking dealer. You can find the nearest dealer by click on the "Dealer" link at http://www.husqvarnaviking.com
Good luck.
SOURCE: Have Viking 990 and feed
Is it that the feed dogs won't go up and down, or that you can't adjust the stitch length? If the feed dogs won't go up and down after you have released the feed dog button and cycled the handwheel one revolution, than there is a mechanical adjustment needed. I the stitch length can't be ajdusted, that It's either a circuit board of a step motor problem. The repair shop should be able to tell you that they swaped the feed motor with the zig zag motor to test this issue.
500 views
Usually answered in minutes!
Did you find value of resistor? I have the same fault
×