Kenmore Elite Drawer Dishwasher leaking

Hi,
You may have clogged pump to the drawer. open drawer, lay on your back under the dish drawer, removed the black cover (3 screws) remove 2 screws to the pump and allow the water to drain out into a bucket or bowl. make sure the pump can turn easy. Reassemble and test unit again. If fails, replace pump.
Pump
I hope this helps, good luck

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

If the dishwasher is completing the wash cycle without any problem then the suds can occur either because you not using correct detergent. This model does not tolerate the tablets. You have to use the powder.
Water remaining in the bottom of drawer is linked to drain hose either blocked or not looped high enough under the kitchen sink.
I would suggest check this document for correct installation.

replace the pressure switch to stop the flow of water that is the cause of overflowing

I am assuming one of the drawers has caused water to leak into the base of the dishwasher cabinet

Disconnect the mains power connection.

Extend the bottom drawer out as much as possible. Use towels and hair dryer to dry out the base - especially the flood switch that is located towards the back middle of the base.

Leave it open until the moisture disappears. Reconnect mains power and try to start one of the drawers.

The water can leak due to kink or crack in hoses or simply too much foam from detergent.

Hope this fixes the problem - hopefully nothing to replace.

About 3 years either the lid seal is going bad or the actuators had a problem. These things prevent the seal from properly seal on the top of your tube then causing a leak to the bottom hosing of each drawer. If you pull out the tube you can see the bottom housing is wet. Based on what you described, I can see the bottom is on the top drawer. When it leaks so much, part of the leak is coming down to the lower one. The flood at the lower bottom housing is less then from the the upper one.

clean all of the freezer seals and all contact points.

Has something fallen behind the drawer, and is preventing it from sliding back all the way? Remove the drawer by pulling it all the way out and lift it up and out. Look for anything that has fallen back there.

I have Fisher & Paykle DW DD603-SS (5Y old)
The upper drawr started to leak H2O out and in to the bothom drawr???
What is the problem and also please what is the solution?
Thanks, JB

If you have a side by side model you need to look at the refrigerator compartment wall on the left of the bottom drawer and move the slide control to the warmer/fruit/vegitable setting instead of the meat setting.
I hope this helped. Please rate my help or ask for more help please. supertechks