LD651EBL CH error - LG LHD65EBL Dehumidifier

Hello everyone, can someone please tell me what is error code CH10 on lg dehumidifier please?
Thank you

make sure the bucket is in the right spot LG LD651EBL Owner Manual Page 15

the float switch above the tank might be stuck. or broken

Thanks for the post by Posted by Bill L on Jul 14, 2012.
I decided to take a chance and order the new Sensor assembly $20.50 and install it in my LG LD651EBL Dehumidifier which was giving me ch 67 errors. Wala, it worked, the error code is gone and the dehumidifier is now working perfectly! Thanks

After cleaning the filter, i had to unplug the unit to clear the ch 67 error code before the unit would run again.

There may be some packing material left in the bucket or tape that is holding the float valve in place. In which case, the float valve may be in the UP position, which tells the unit, that the bucket is full.
Check the top of the bucket for the float valve and make sure it's in the DOWN position. Reinstall the bucket 'squarely" in the bucket holder and making contact with the bucket safety removal switch on the rear wall of the bucket holder.

If this continues to happen, consult the Troubleshooting Guide in the Owner's Manual.

Hope this helps and thanks for choosing FixYa.

Make sure the bucket is installed properly. It you are CERTAIN it is installed properly and you still get no power to the unit (you said you definitely have power at the wall outlet) return it to the store and either get it demo'd or replaced. Definitely rule out the wall outlet by testig with a light or a radio before you load the unit into the car.

Any more than what I have suggested may void any warranty you may be entitled to. Don"t wait.

Thank you for your question @ FixYa.com

We;ve managed to clear this error, at least for the last 5 days. Remove the bucket, and reach up behind the front panel where there is a filter- ours was covered in dust. After cleaning this off, and resetting the machine (by pulling the electric plug out and re-inserting), the error went away.
Your mileage may vary.

Your model is no longer in manufacture or available. However, I was able to locate the Owners Manual for you. It does not list a CH 01 Error Code, but does list other reasons why your unit want turn ON.

http://www.lg.com/us/support/product/support-product-profile.jsp?customerModelCode=LHD45EL&matchedModelCode=1000001989&searchEngineModelCode=LHD45EL&targetPage=support-product-profile&initialTab=documents#

In the past, I have recommended turning the Master ON/OFF Switch to OFF and unplugging the unit for 12-15 minutes. This will give the unit time to hopefully, reset itself. Then Plug the unit back in and turn the Master ON/OFF Switch to ON. Set the humidity control as you normally would. If it successfully reset itself, it should operate normally.

If you continue to have problems, contact LG Customer Support at 800-243-0000.

Hope this helped you to solve the problem.

I have a Comfortaire BHD501 dehumidifier. A couple weeks ago I noticed ice building up on top of the unit,so I unplugged it to defrost. I plugged it back in and it worked until I noticed the "CH" "01" code. It would run a few seconds then shut off with that code showing. I took off the front of the unit and noticed rust on some of the metal parts. Then I took the cover off the circuit board for the front read out. I noticed corrosion on some of the solder points. When I looked closer at the plastic cover for the circuit board I noticed a small burn mark. The water from the melting ice must have run behind the cover and shorted out the circuitboard. At this point I don't know if new boards are available.