Phillips sdtv blinks off and on why - RCA F32650 32" TV

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.

5 blinks 5v SOS D-Board.
For more details, search for any service help site. I've all details, but this window do not allow me to upload pictures or PDF documents.

Lamp cannot be tested like a regular bulb--if set shut down you should have some kind of blinking light up front---lamp possible but not likely as it should trigger the lamp light.

Either guess or call an expert to examine it.

hi,
Try the any one of the following code.
150,259
ok

Sounds like the Regulator IC went bad. It's best to take it in for service.

Hi

On the URC 4330 model the Magnavox brand is not listed in the code index.

Therefore, you should be aware that this remote may not have code stored in its pre-programmed library to allow it to operate Magnavox.

There is a code search function with this remote and this is your only other option in a situation such as this.

TO SEARCH FOR YOUR CODE FOR YOUR TV

1. On the remote control, press TV once.

2. Press and hold SET until the LED blinks twice, then release SET.

3. Enter 9 - 9 - 1.The LED will blink twice.

4. Aim the remote control at the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off.

NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first so this may take some time to complete.

5.Once you find the point at which the remote operates the TV press and hold SET until the LED blinks twice, then release SET. This locks in the code.

As I say - the remote may or may not compatible with Magnavox. However this search function is there to use in situations such as this.

Hope this helps. Thanks for using FixYa.

its 0581

Need code for the remote

Ur power inverter board is dead.
U need new one.

Sylvania is a branch of North American Phillips...Phillips\Magnavox\Sylvania are all the same. If you can't find one that will work you might try tritronicsinc.com to order a replacement remote. Usually a universal remote doesn't give you access to the menu or changing inputs. Good Luck!!

barneyluc