Capacitor locations on 1080p - Mitsubishi WD-62525 62" Rear Projection HDTV

bad power board look for swollen capacitors

Samsungs have a habit of using faulty capacitors on the power-board. Remove the back cover and look for swollen capacitors on the power board. If they are swollen, you can de-solder the bad ones out, and solder new ones in.

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electro-medical.blogspot.com/

Fault to its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Probably needs new capacitors on the PSU board.

Most likely it's a capacitor fault.

Google "Capacitor bulge" and then search Youtube for your make and model to see if anyone has done an instructional video. You'll need to be comfortable dismantling the TV and be able to use a soldering iron. If this isn't you then take it to a repair shop.

You need to describe what is the source. Sometimes the input selected on the TV needs to be changed. Try pressing a video or source button on the TV itself to see if you're looking at the right input source. Sometimes you will have five or more inputs like HDMI and Composite. Look at where you connected the input signal and see what it's called, then look for that input on a menu of some sort.

Hi, I have a Philips flat screen tv that has four bad capacitor. I maded an mistake of removing them and didn't mark the location for reinstallation. Where can i find wire diagrams or schematics for an Philips/42pfl7403d/f7 tv. Please Help. Miller

About which capacitor you are mentioning about?

It will not display 1080p if the video signal is not 1080p, the video signal dictates what the TV will display. Your vidoe source must be 1080p.

Basic LCD monitor and TV troubleshooting guide:
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/

Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague

Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you.
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series.