WATER IS RUNNING EVEN WHEN IT IS OFF

You say it says water flowing. But, is it flowing? Does it overflow? If so it may be overflow switch on the bottom that got food stuff in it.

the fill valve solenoid assy (mix valve) needs to be replaced. One of the solenoid valves is not seating properly letting water flow into unit even when not running Easy fix all you have to do is shut off the water supply, disconnect hoses remove the top of unit ,three screws in back,slide top towards back..the rest will be easy Good Luck

That is the cistern overflow running.You need to adjust the fill level in the cistern by adjusting the plastic screw on the ballfloat or adjust the height of the float if its the silent fill tpe

Your dishwasher water fill valve is defective. Remove power from the DW. Remove the bottom toe kick panel. The water valve has the incoming water line connected to it.Remove the wires from the valve. If the water stops entering you have a bad timer. If it makes no difference you have a bad valve. The valve is a replaceable part. The timer is a replaceable part.

If it fills with water and starts the cycle and the water keeps running in then your water inlet valve on the back where the water supply comes in is sticking. It needs replacing.

check to make sure the control knobs are turned to exactly small -med -or large - if it's in the middle of say med and large loads the water will over flow - this happened to us three times (cause of daughter!)

Water valve is stuck open, probably by lime or calcium build-up. Proper fix is to replace the water valve. How old is the washer?

This sounds like, the 550 transformer is not connected to the blower motor power connection (in parallel)

Intrrnal leak into base of appliance will make drain pump run constantly.
If appliance fills then dumps water with drain punp then keeps filling/draining sequence then the flow meter could de faulty.
Call in engineer.
Paul Winn Appliance Services (Cumbria)

Sounds like a bad mixing valve. To verify that it is the valve you need to turn off the washer when it is filling. If water keeps running, replace the valve, Cost is under $50. for most washers.