Question about Whirlpool RBS275PD Electric Single Oven

1 Answer

Accubake oven broil on while bake is on - Whirlpool RBS275PD Electric Single Oven

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Whirlpool Master
  • 5,420 Answers

Did u by any change do any work inside that may have reversed the wiring? other wise check the oven relay board and the wiring behind the bake broil switch

Posted on May 18, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

SOURCE: Broil turns ON when pressing BAKE button on RBS275PD Whirlppol oven

Our Whirlpool oven just started doing the same thing!!!! The Delay Start Time (setting it for one minute ahead) and then Start works just fine.  But we fried the tops of three loaves of homemade bread!!!!
Is Whirlpool just a bad brand for ovens?

Posted on Feb 17, 2008

Anonymous

  • 1 Answer

SOURCE: Whirlpool Accubake oven super capacity series 465

In an attempt to self clean my oven, I pushed the auto clean button and then pressed start. Instead, nothing happened, but now have a message on the panel reading E1on the left side of panel and -F5- on the right side of panel. I am unable to clear it or operate the oven now.

Posted on Nov 25, 2008

Anonymous

  • 2 Answers

SOURCE: whirlpool accubake oven problem

I had the same problem and followed the process listed above....yes, I did unplug/turn off the circuit and am alive to share this update! Right off I noticed that the ribbon cable was loose. For those who have tinkered around with other electronics such as a PC, etc., note that this ribbon cable is not secured by the connector (atleast in my case). Reseated the cable and turned the power on. Voila- the bake option works. Tested it by turning it on for 20-30 seconds. Touched the bake element and got proof that it was working fine (via a singe of the ring finger ;-)).

About three minutes or so later, the display started to beep with an error code - E0 F2. A shorted keypad is what it stands for. The clock was still operable. I could still select the bake option, broil option, etc. Ran a test bake cycle but it turned off after a minute or so and started to display the E0 F2 code again.

Started the process all over ie turn power off, take panel off, reseat ribbon cable. Turn power on and test by holding the Cancel button for five seconds. Still displays the E0 F2 error. Waited for 10 minutes but this time no more beeping or error display. Ran a preheat cycle for 4+ minutes without any problems. The oven warms up and the bake element glows red. Hopefully, all is well. Will see what it does when we bake something the next time.

Thanks to PropHeadTwo and others for their contributions.

Posted on Dec 18, 2008

Mark Egan

  • 1214 Answers

SOURCE: Maytag oven top heating element won't come on unless on broil

You are probably going to find the lower heating element has failed. Your symptoms describe that failure exactly.

Reply back if you want instruction as to how to repair.

Posted on Feb 16, 2009

EllaWatson25

Ella Watson

  • 725 Answers

SOURCE: I have a Whirlpool Self

When you use your self clean feature, your oven heats up to over 800 degrees and this normally takes your electronic computer control board out.

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Element heats up when we only put oven light on


Stove will not turn off CHECK

Temperature Control Thermostat


If the oven won't turn off the oven thermostat is often the cause of the problem. The electrical contacts inside the oven thermostat can weld themselves together and then the oven won't turn off. If this happens, turn off power to the entire appliance at the household circuit breaker or fuse. The oven thermostat usually cannot be tested and must be replaced if defective.

Oven Control Board


The oven control board has a set of relays that turn on and off power to the bake and broil circuits according to the customer settings and sensor input. If the oven won't turn off it could be that one of the relays on the oven control board is shorted closed, providing voltage to the heating circuit. It can be dangerous if the oven won't turn off. Don't leave the oven unattended without turning off power to the oven.

Relay board:
Some ovens are equipped with a relay board. This circuit board has several relays which control the switching of electrical current to the oven heat source. If the oven won't turn off it may be that one or more of the relays on the relay board have failed. If this happens replace the relay board. The relays on the board are not sold separately. ALSO CHECK THE BAKE AND BROIL ELEMENT.

Nov 17, 2014 | Whirlpool RMC305PV 30" Built-in Microwave...

1 Answer

Maytag double electric oven. we turn on to bake and would switch to broil then will turn off.


Assuming this is on a gas range, the bake burner ( under the oven floor) and the broil burner ( at the top of the oven) have electric igniters . When switching from bake to broil the broiler goes off due to a defective or broken broil igniter. cheap part to replace ( +-$40.00)

Oct 16, 2014 | Maytag Ovens

1 Answer

My oven will not heat up to temperature


It may be the bake element that has gone out. The self clean usually uses the broil element to heat the oven. And most oven will either put 120 volts to the broil element while baking or pulse the broil element while baking. This will cause the oven to get warm but not hot. Check the oven bake element it cound be bad or a wire may have burned off.

Feb 14, 2014 | Ovens

1 Answer

Whirlpool oven/stove with accubake. The cook top works with no problems the clock and display work with no problems. The oven does not work at all no bake no broil. Got it to work a couple time by...


Take a look at the oven ignitor,you might have two.The one at the top is the broiler ignitor.And the one at the bottom is your oven ignitor under your lower oven plate.

Feb 21, 2013 | Ovens

1 Answer

Frigidaire oven fefl68 broil element comes on on broil only will not come on on bake or clean


Hello - - If you are referring to the bake element, but the broil element works then you would need to just replace the bake element. If both your bake and broil element does not work, then there might be a problem with the wiring communication. However, if the oven does not bake and/or broil but the cook top works; contact a professional to diagnose the EOC (electronic oven control).

Nov 17, 2012 | Ovens

1 Answer

Whirlpool gas oven will not heat


most likely you have a bad ignitor,pull out the racks and remove the floor to the stove,turn on the bake,if the ignitor glows but it takes more than 40 seconds for the flame to light you have a bad ignitor even though it glows and if it doesn't glow at all the ignitor is bad,also if the broil lights on top and the bake doesn't change out the ignitor.next time send the model number and i can look up your machine to help you better.

Nov 15, 2011 | Whirlpool Ovens

3 Answers

Getting oven back on fahrenheit instead of celsius


Actually for the Whirlpool Accubake I just figured out, the bake button didn't work, but holding the broil button did the trick.

Apr 19, 2009 | Ovens

1 Answer

GE Oven JTP15BW Broil Element on, Bake Element off during baking.


I have the same problem. Just swap the 2 wires that are marked as 'broil' and 'bake' on the controller board. But sometimes it switches back, then I have to swap the wires again.

You might want to leave the 'broil' post unconnected to prevent burning food..

Nov 21, 2008 | Jenn-Air JJW8530C Expressions Collection...

Not finding what you are looking for?
Whirlpool RBS275PD Electric Single Oven Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Ovens Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Cindy Wells

Level 3 Expert

6048 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Are you a Whirlpool Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...