Aeg dishwasher dont worm the water - AEG 24 in. Favorit 3A Free-standing Dishwasher

Some companies share generic codes like 'Lw', for low water level or 'DL' for Door Lock. This might help, there are other sites when Googling 'make model error codes'.

AEG Dishwasher Error Codes ' Dr. Dishwasher

www.drdishwasher.com > manufacturer > error-codes

Error/Fault Codes for AEG Dishwashers with an LED Display Fault Code ,10 Symptom: Dishwasher not filling with water. Go to: Why is My Dishwasher Not Filling ...

See if this site helps -

Dishwasher Repair Help

You might like to try the AEG site for manuals and troubleshooting

AEG UK Visit our AEG support service page for manuals and troubleshooting

The most common cause of a fault "i10" is closed valve on the water supply line. So this failure indicates a problem with filling of water.
Possible error causes:
Closed water tap, Inlet valve faulty, inlet hose bent, softener system clogged, pressure switch or pressure switch hose obstructed or leaking, wiring from pressure switch to printed circuit board (PCB), wiring from inlet valve to PCB and finally PCB.

Dado

Go here http://www.aeg.co.uk/Support/Manuals/ and put in the model nimber and problem and a tech will contact you.

AEG OKO FAVORIT 40300 When switching dishwasher on no water is flowing into the the dishwasher

Please help

If the water isn't getting hot, then either the water inlet valve that opens the hot water is faulty or the heating element that heats the machine may be bad.

This is typical of a water leak onto electrical connection OR the electrical element has shorted internaly . Check this with a Ohm meter and itshould show the problem

I had this same problem on our AEG dishwasher. The reason was on the controller board. There is one relay switch which drives the heater element.One of the legs of that relay box was disconnecteds from the circuitboard. Check this out.

Just fixed a similar problem on an AEG F3A by following other advice on this site. Simply tip the machine forwards on to its door (best empty it of crockery first!!!).and then put it upright again when water has stopped dripping out of it. You wil get quite a bit of water on your floor which I reduced by pumping the water out of the salt resevoir first - but if you don't have a pump just have several towels handy