How to sync hands and digital display on rado diastar

I bought watch from online website mirraw check it out here

http://www.mirraw.com/store/watches

hi the watch i found is pretty much identical. only thing is anchor is at different angle. points straight down not to the right and its a females watch. price is bout 506 pounds or 895 dollars. hope this is useful to u.

Just go to your local service center found on www.rado.com and they will replace the link for you for about $25.

Hi - I have a Rado Jubilee-Black Face-Lovely Dial
Problem:Time is set with a Key - Back of the watch
I have LOST this Key & need to buy or get one?
Can you please advise - [email protected]
Many Thanks
Ms>Mohamed

You can adjust the analogue hands without changing the digital ONLY when you have set the watch to 24hr fornat. Do this by going to the second Timezone screen (T2) and pressing the crown once briefly. If A or P appears, the time display is in 12-hour mode. If no letter appears, the time display is in 24-hour mode. To change mode, press crown briefly a second time.

Now go to the basic display where no digital info is shown. Pull the crown out. Now slow turning will adjust the minutes and fast turning the hours, but only of the hands. Therefore you can synchronize the two. After they show the same time, press the crown back in and adjust both times together using the crown as normal on the standard "Time" digital screen

mcdevito75 here, Best Bet with your Rado watch, Look for a small watch repair shop in your area for adjustment / replacement.

If it is a Hi-tech ceramic watch with multifunction display, then the market price should be around US 2,000.

I bought the same watch recently and have the same problem. The hours can be adjusted in the dual time zone by looking up the manual, but the minutes stay put. I can't bring them to blink so that these could be adjusted. Any ideas? I sent a mail to Rado through their website but no answer.

Hears how i do my watch, i have the same watch as you.Just make sure nothing is displayed on the clock face by turning the winder, ie NO digital time, NO daul time, NO alarm, NO stop watch etc, Pull out the winder(crown) and adjust the hands to the time you require by spinning the winder.(Gentley for mins and fast for hours) The digital clock will display wilst doing this, but not change the time.handy if you want to sync both clocks.Push the winder back in at the time to sync and the digital display will go out, then spin the winder again if you want to display the digital features. I hope this helps, please post if it does, Maurice Chevalier- Herts