How to program taxes - Royal Cash Register 500dx

You set the rate in the tax rate program then you set each department as taxed or no tax. If it is affecting all depts, you need to look up department programming and set tax (usually tax1 to 0 or off) in each dept

That is the correct program it seems your program is corrupt, just wipe out everything and start afresh

Firstly, change the rates for each tax in the tax rate setting tables of your manual. Then you need to turn on tax rate 1 and 2 for departments that need both. This is done in the department programming tables. Tax setting can be quite involved so follow the tables carefully.If you need a programming manual, One of the users has it here:

http://the-checkout-tech.com/manuals/cashregisters/Casio_PCR-T2000_users_and_programming_manual.html

The two main programs to edit are the tax rate program and the department program. have a look at these tables in the manual and set your tax.
If you need an XE-A41S manual, there is one here:
http://the-checkout-tech.com/manuals/cashregisters/Sharp_XE-A41S_programming_manual.html

Key to Program enter 3 subtotal 1 tax pgm (tax rate with decimal) cash tend subtotal.
ie 7.35%
3subtotal1 tax pgm 7.35 cash tend subtotal

Download the manual from Casio's website for the specific model and follow the instructions to re-program tax. See Program Tax in the Index. Page 87 I think

Use Tax Turbo

Hi.
I have never heard of an 8700. I have info on the 8000 and 8500 so it may be similar to one of these. If it has never been programmed to use tax before, then I will need to know how your tax system operates. Do you use add-on, or add-in tax, how many rates? Are all PLUs taxed, or just some?

Mark

Hi. If you bought it new then your dealer should have set all of the system options for you so it is strange that the tax is not programmed. Normally you would only need to set the rate when your tax rate changes. Has it been calculating tax at all? Did it come from your dealer with a standard program in it?

I'm in Australia and only going on the program manual for your area, it states that canadian tax is tax on tax? if this is true then you probably entered a code for add on or add in tax and thereby changed it all.

you need the following

tax table address
1 125
2 225
3 325
4 425

rounding off codes
rounding off to 2 decimal places is 50
rounding up to 2 decimal places is 90
cut off to 2 decimal places is 00

tax system code
tax table with out tax rate 01
tax table with tax rate and add on rate 02
add in tax rate 03
Canadian tax-on-tax rate 04

starting point
to get the starting point you multiply by 100 and subtract 1
eg 50 cents = 0.50 X 100 - 1 = 50 - 1 = 49
eg $4 = 4.00 x 100 -1 = 399

to program the tables go through these steps

go to program 3
tax table address eg 125
subtotal
tax rate
ca/amt tend
starting point eg 0.50 = 49
ca/amt tend
rounding eg 50
tax system eg 04
ca/amt tend
ca/amt tend

here you have 2 choices,

press ca/amt tend to go to the next tax table ie 225 and start over by entering the tax rate and go through the procedure again

or

press subtotal to finalise the tax table you are on

Hope this helps,

Adam