How to uninstall overrange microwave - Maytag MMC5000 Microwave Oven

Remove two phillips screws from each side of the microwave. One at the very top and one at the very bottom. Remove the front cover. There will be a couple of other screws and metal stops under the microwave that will need to be removed also. After that, the back of the microwave will need to lifted and move forward just a bit to release the back. Pull the microwave forward and toward the left side, enough to be able to reach behind the right side of the oven and unplug the microwave. Remove the microwave. To reinstall, just reverse these steps. It might help to use a mirror and check out the 110v 60Hz socket in the top right corner of the oven that you will need to plug the microwave back into when you replace it.

which is model?

It sounds like the magnetron may have either failed or is not being supplied with the extremely high voltage required to run it.
Make sure the !!!!capacitor is discharged!!!!! before attempting any sort of repair.
Check the door interlock switches first then the high voltage diode with either an AVO model 8 on high resistance range for short circuit, the capacitor can fail and go short circuit, the feed fuse on the primary of the high voltage transformer and then finally, the magnetron is best checked by substitution.
Hope that helps.

microwave works no heat

pls help me now my sanyo machine have problem

You can download GE owner's manuals and installation instructions here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

You can download GE owner's manuals and installation instructions here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

You can download Kitchenaid/Whirlpool owner's manuals and installation instructions here.

They're very handy when uninstalling them too.

If you have a problem with your microwave, we may be able to guide you to an affordable repair.

If you're interested, please reply back with your brand and model number as well as your symptoms so we can help you.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Advantum 120 over range microwave - with burned out interior bulb: Remove top fron grill cover -- held byu 2-3 screws on top. Remove sheetmetal plate that lies parallel to top of unit, just to the right of the square plastic porting on the far left of the unit. The sheet metal plating is about 12" wide and 8" deep and is shaped like 2 overlapping rectangles. It is held in place by 1-2 screws. (I don't recall if you needed to remove other plastic grid on right front -- I did, but I was still searching for the bulb). The bulb is located about 5" from the left side and about 2" in from the front, covered by a small sheetmetal box. THe bulb looks like the little halogen bulbs used in low-voltage outdoor lights - but is slightly larger - DO NOT REPLACE WITH THAT KIND OF BULB). Remove the one screw holding the box, unplug the bulb and find a replacement. Can't tell you where to get a bulb -- that's what I'm doing next. Good luck.

If you don't have the installation instructions, you can get them here.

They're very helpful when installing OR uninstalling.

We're happy to help and we appreciate your thoughtful rating of our answer.