I have a blicking red light and no picture ?

Lamp needs to be replaced. Contact Mitsubishi for a replacement. Cheapest available and is OEM.

Greetings,

Power supply cannot sustain / provide juice to the whole system.
If you are qualified to do electronics, check the power supply section, otherwise contact a repairman.

Keep us posted and thank you for using our service.
FixYa for all your troubleshooting needs.

3 times standby red light blinking shows that lamp cover has not been placed back properly after lamp replacement.
Make sure lamp cover, (the first thing that you removed to replace lamp in tv) is fixed securely then turn tv On.

it is going in safeguard mode there is some problem in circuit

it will need a new light board or you will need to turn the brightnees up

if the sound is working you need to replace the lamp and reset the lamp use hours.

Your TV is in fault protection. Due to blows caps on the PSB-power supply board.

Best Regards and Semper Fi

THE BLICK IS A CODE IF IT BLICK 2 AND PAUSE MEED NO WARER OR THE ICE MACKE MODLE IS AD IF IT BLICKS 3 PAUSE THE TRANMITER IS BAD.

Watching normal tv when the tv shut off and the red lights blicking only

Power supply or scan failure is the usual cause. You will require service for this set.

Jerry G.