Where is the float switch in a lamona dishwasher

Are you sure it isn't HJA8630?

It appears to be unknown where I am in Canada. Generic door seal replacement videos. They all follow a theme.

https://www.google.com/search?q=Lamona+dishwasher+replace+door+seal

https://www.google.com/search?q=Lamona+HSA+8630

..

There are two ideas on this! The flood switch is more likely. There is a plastic tray above the floor and below the pump. The flood sensor is in the tray.

Error Code E01 - this error code usually relates to problems with the door lock (in some models this is indicated by error code E07). Checks will need to be made on the connection to the circuit board and to the lock itself, for any broken wires and to see if the interlock is faulty.
Feb 12, 2020

Lamona Dishwasher Faults And Troubleshooting

Exclusive Repairs https://exclusiverepairs.co.uk > Blog

I've got an integrated lamona 8606 whith an E-01 error code.

JustAnswer https://www.justanswer.com > UK Appliance Repair
Aug 21, 2020 - E-01 error code means water has leaked into the base of the dishwasher and activated the flood switch. What you need to do is unplug the ...
1 answer · Top answer: Yes that's the base. The flood switch is towards the middle so make sure

..

Question edited for clarity and spelling of 'integrated'.

This explains

https://www.justanswer.com/uk-appliance/83k9f-lamona-dishwasher-hj8630-need-replace-door.html

The videos are for a Kenmore, but they all work in a similar fashion.

If the display screen of your Lamona Dishwasher (LAM8606) looks glitched, it is likely due to a hardware malfunction. To troubleshoot this issue, try unplugging the dishwasher for a few minutes and then plugging it back in. If that does not work, then it is best to contact a qualified technician who can inspect the appliance and make the necessary repairs.

Dishwasher Push Button Switch Replacement - Bosch ...

? 1:56
https://www.youtube.com/watch?v=MSO3nXetiOM
Oct 8, 2012 - Uploaded by RepairClinic.com
This video provides step-by-step repair instructions for replacingthe push button switch (or on/off switch ...

could be a water inlet valve. Turn off water supply....disconnect hose at dishwasher....turn water supply on slightly to ensure water supply and hose are ok. If you have water there , problem could be water inlett valve or perhaps a sticky float valve.

Where will I find the thermal fuse ?

Probably a bit late for the original poster, but I found this page after searching with the same problem. You can actually fix this yourself. I had exactly the same problem - if you take the front off the dishwasher, the switch module is inside a grey plastic moulding. If you remove the two cable plugs and remove the two screws holding the moulding in you can then take it out. Carefully open it by pulling back the clips, and inside is a small circuit board that slides out. On one side are the two microswitches. I got mine working again with some switch cleaner. If that doesn't work, you should be able to get a new switch soldered on by any electrical repairer. Obviously, yours may be slightly different as I don't know what model dishwasher you have, but mine is a Howden's/Lamona too, so it's probably very similar. Good luck.

we have a howdens dishwasher model number hja8630, which is full of water which hasnt drained . i have ladled it out checked filters are unblocked but it still fails to start. it does a click click sound and then nothing . only 18 months old and only ever used twice a week