My Sharp Copier AR 5127 resulting an error print out. i.e. printouts are waved. pls. give a solution if possible.

get your driver from http://www.filecrop.com/sharp-ar-5127-driver.html

In fax mode, touch the [SPECIAL MODES]
key.

Touch the [TRANSACTION REPORT] key.

If you want the transaction report to print regardless
of whether the transmission succeeds or fails, touch
the [ALWAYS PRINT] key.

Touch [PRINT ORIGINAL IMAGE] checkbox

Touch the outer [OK] key.

u2-40 is communication problem in mainboard,try to replace the toner cartridge. or reset by programming. here the programme...on the mechine then # interrupt 0 interrupt. if mechine go sleepmode pls press 14 and start.

This means that the cartridge's sensor is miscommunicating with the copier memory thus the code U2 -40. You should clean the inner sensor connector and the toner sensor of the spilled toner by low blower. Perform this code ;# , interrupt , C, Interrupt keys in that order and press 16 then Print key and the code will be cleared.

ERROR CODE U2-4 COULD BE RELATED TO THE MEMORY BATTERY BEING DEAD ON TEH MAIN BOSRD IF IT IS AN OLD MACHINE SO YOU COULD CHECK THSI OR REPLACE AND TRY WITH NEW

Sharp Fuser
H2-0 Fusing unit temperature error
H4-0 The fusing unit doesn't heat up.
***ALWAYS DISCONNECT POWER WHEN WORKING ON MACHINE***
You have to reset fuser errors with simulation 14. Push P * C * then 14 then Start (the button you use to make copies) and it should reset the code. If not then replace the fuser.
SM 5-1 should turn the lamp on. If lamp blinks on and off it is the thermistor, if it does not it is the lamp, but check the contacts on the lamp/fuser -- they have been known to erode.
Also check thermal fuse, if defective replace.

go to percision roller in phx arizona you can get all sharp service manuels i have alos seen them on ebay?

Hi My Error is
code h4-00
sharp AR-5127
please help me

U2-40 is a board error, F1-15 is finisher lift motor error.

To reset: #, interrupt, clear, interrupt. (screen should say service mode), enter 16, print, are you sure? , yes.

For the finisher error, follow above procudure, entering 14 instead of 16. if error returns, disconnect the finisher

Unplug the Machine, remove the board you installed, re-seat the board,
make sure everything is connected, turn machine back on..

This is what the Manual says:
IMC PWB communication trouble (Timeout)
Check the connectors of the IMC PWB
and MCU PWB.
Check the grounding of the copier.

If you need further help let me know..