What is usb good for.

if it is a usb charger cable with a mini usb at phone end and usb at the charger end
just plug the charger end into the pc pr lap top and it is a usb cable to down load from the phone

Problem may simply be with USB cable used. Try another cable, preferably a known good cable.
Problem may be with the socket on the device itself where the USB cable fits in. Try (with known good cable) on a flat surface with the both the device and the cable resting on the surface - i.e cable should not hang down and put weight on the socket.
Hope that fixes it.
Further advice. Even if problem seems fixed, immediately back up the drive if you can!

Hi There,

Its not only happen in you IPhone cable other USB equipment also get this error, This error will come when the USB cable have a fault, so change the USB cable and try again.


Thanks

Your USB hub cannot provide enough power for your external hdd, you can try to plug it in directly to any free USB port for the mean time to check if its detected or not, if it has a power button ( which is not normal for regular USB powered EXT HDD) make sure that it is on, if its still not working try to use a different cable, a known good cable or plug it in to a different computer to check if its your USB port, or the usb cable or the ext hdd that is causing the issue

Hope this help.

be sure that you connect usb cable between pc usb port and monitor usb port and try its usb

good luck sir

You need a Printer usb cable. It is now common that company don't offer the cable with new printer. You can use an old one or buy a new.

Since you haven't used it after opening the box, the usb port's connectors must have got rust on them. Disconnect the cable, clean the usb ports on both the computer and the printer using a soft brush dipped in alcohol/acetone. Also clean the usb cable terminals with the same materials.

After they are dried, you can try the connection, if the problem persists, use another cable and try it on another usb port or if possible on another computer. You'll be able to find out the culprit.

Good luck.

Thanks for using FixYa.

Make sure you're plugging the USB cable from the machine into a USB port in the BACK of your computer, not one of the front ports or a port on a USB hub. The cable and machine need more power than most of those ports provide, a technical detail that Singer doesn't realize. Good luck!

I had similar problem with my UMAX scanner on numerous occasions. I now have this pg earmarked for quick reference! may help I don't know for sure but it is an easy test and if it works your good to go!
It is important that you connect the scanner's power and USB cables in the following order:
1. Plug the power adapter cord into the scanner and into an outlet. The scanner's power will then be on.
2. Connect the USB cable to the USB port on the
back or front of the computer.
NOTE: If you unplug the scanner's power ,you must also disconnect the USB cable from the computer. To resume use of the scanner, remove the power card, the the USB cable.

Sounds like a lot but the order is essential!
If it works, High lite Do unplug USB/unplug cable back of scanner/and plug cable back of scanner then USB!
Good Luck Hope this helps!

The cable you need is a:

USB A Male to Mini B 5-Pin Male,

And you can find it almost anywhere as this type of cable is very often used to link many USB devices as cameras, mp3 players and cell phones. So if you have one from other camera or USB device just shift.

Good Luck...