How do i get the motor to be quieter? - Hayward 1.5 Hp Northstar High Performance Pump

well is the motor inside the ice maker running ? if so this could be the reason that you cant get bucket off (interlock to prevent ice from dumping into freezer) motors do get noisy after a time , a new one will be much quieter .

In most cases the quieter the better. There is no motor per say, since computers are made of, chips, transistors, capacitors and other solid state items. The only moving parts are fans, and spinning discs. Including hard drives.


Hope this helps identifying, and narrowing down your concern.

your fan motor touching the ice formation when occur..adjust your fan motor blade,or your fan motor .to avoid making noisy all the time.

Hi,

When motor is running, look to see if the cutters are turning. The cutters can be seen by looking into the throat of the shredder. If the cutters aren't moving, the gears may have been stripped and shredder needs to be repaired or replaced.

Good luck.

This is a sealed bearing motor so there is no oil ports. You can blow out with compressed air and spray motor shaft with WD-40. Be careful not to spray any lube inside motor. If you can get to them blow out motor cooling ports .this should help motor run cooler and quieter. Hope this helps you. Thanks

It is most likely going to be between 5 and 15 degrees BTDC. I would put it at 5 degrees BTDC. At idle, if the motor is extremely quiet, but the exhaust loud, move it to 10. As you advance the timing, the motor should become louder and the exhaust quieter (at idle). As you increase RPMs, the motor should get quieter and the exhaust louder. This is only true with an injector pump that has static timing (does not automatically increase with increased RPM).
If your engine has dynamic timing (automatically advances with increased RPM), then I would set the timing at 5 degrees, test run. Maybe change to 7 degrees, test run...etc. Basically, don't make dramatic changes with the injector pump timing if it is dynamic. I hope this helps.

If motor is sounding quieter than normal more than likely the belt has broken.

If you can hear the motor spinning and the window isn't going up or down the gears on the motor or regulator might be stripped. Some vehicles use plastic gears on the window motor making it quieter however more prone to problems like yours.

install a smaller motor
the reason it is so loud is that the motor is tuned to a certin back presure so exhause provides this
ask the dealer if they have a quieter exhaust designed for the bike they might and at least you sill get a solid answer

needs a new belt. belts need to be replaced every 2-4 years or as needed. most likley will fix your problem and is a cheap and easy fix