Says FL and won't run - Maytag Neptune MAH5500B Front Load Washer

Make sure the camera hot shoe is clean and also the spring assisted contacts on the flash as in for order.

https://www.google.com/search?q=Olympus+Fl+36+flash+won%27t+access+TTL

..

Check the midi channel. It needs to sync to FL Studio. Channel settings you'll need to look up in the privia manual...can be laborious - but worth it in the end :)

replace door latch (fl = faulty latch ) good luck APPLIANCES R EN

USE A VOLT METER , START AT THE BREAKER AND WORK YOUR WAY TO EACH DEVICE. THIS WILL HELP YOU TRACK DOW THE POWER ISSUE .. JAY THE POOL PUMP MOTOR REPAIR GUY IN LONGWOOD FL

I think what you are seeing is "FL", rather than HL. FL indicates that the water collection bucket is FULL & needs to be drained. Sometimes. the LED letters on the screen can be hard ti read.

Hope this helped you and thanks for choosing FixYa.

I would say that the FL probably means FILTER its more than likely dirty and should be cleaned

FL error - Flood condition

"FL" flashes if any overfill condition occurs. This condition occurs when excessive water in the tub causes the overfill switch to trip. The control must realize that the trip was due to an overfill condition instead of a suds lock condition in order for "FL" to be displayed.

With an overfill condition, the beeper repeats a warning every 10 seconds with no time out. The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit. Press STOP/CANCEL to clear the display.

You coudl se this manual: Service_Manual_PDF

Hope this helps.

Hi


Thanks for using FixYa. Error LF indicates long fill, which flashes when the water level won’t change for a period of time after the valves are turned on or the water has disengaged the basket but control does not detect a water level change. TO resolve this issue check if the water supply is turned on and the hose screens are not plugged or kinked. If the water is not entering the machine then check the water valve, also check the pressure hose connection to the machine/motor control. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Make sure it is allowed in firewall and all drivers are downloaded and program is enabled.