Gears on turntable making noise - Technics SL-BD20D Turntable

If the turn table automatically picks up the tone arm and starts the record and changes after the record is over, then you are haering the gear box.

see for the turn table obstacle of any screw or something else.

Check on vinylengine.com for a Users Manual. You can download it for free once you register. The gear wheel might not be set right. If that doesn't help, pick up a 6100 Service Manual. I think I bought mine on ebay for about $10

Try soaking the turntable when you wash up in washing up water as the wheels can cause that, otherwise replace the motor.

The turntable system typically consists of the motor, the coupler, the turntable support with rollers, and the tray.

Here is a video of how a turntable motor should sound when you rotate it by hand.

If yours is not set to be off via the control panel, and it won't rotate or it sounds like it's grinding, etc., you may have a bad motor or plastic coupler.

To replace either, you need to unplug power, then remove the bottom cover of the oven.

You can find helpful exploded view diagrams and order parts here.

I'd recommend that your bookmark this link to your favorites.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

there is a gera rotating the turn table, and because of the frequent usage, it needs to be chack up and clean and be lubricated so the the gear and bearing can turn smoothly, if you can access the rotor(the gear that makes the turntable turn) try to clean it and put some lubrication (grease or a oil)

if you havent had your player repaired then you can contact me @ www.audiovisualservices.info

Hope this helps you.

Thank you.

The problem with turntable motor or coupler which sits on turntable motor shaft.

I’m happy to help further over the phone at https://www.6ya.com/expert/vitaliy_f406165329c75ede

it may be the fan/fan cover assembly or it may also be the magnatron, after a while of use, before faulting the plates inside dislodge and can rattle around while in use.

I have the exact microwave you do (ems8000w), the motor failed and I found this one worked perfectly as a replacement.

The original is impossible to find.

https://microwaveglasstrays.com

1 x 120v Microwave Turntable Motor 6RPM 4W # F63265G60AP (F63265G60AP) = $14.99
Good luck.