I have a error on my camers and a flashing question mark

question edited for clarity.
Question moved from MISC.

alternately flashing blue and orange lights

Error Lamp Flashes Orange Pro9500 Mark II

https://support.usa.canon.com > ...
May 11, 2015 - When the Power lamp flashes blue even though the printer is not in use, the printer is shaking the ink tanks. It takes about 10 seconds to 3 ...

Alarm Lamp Flashes Orange - Pro9500 Mark II Series

https://www.manualslib.com > ... > On-screen manual
Canon Pro9500 Mark II Series Manual Online: Alarm Lamp Flashes Orange. Advanced Guide Troubleshooting Alarm Lamp Flashes Orange When a printer error occurs, ...

Do you get any numerals in the TOP LCD? Say a flashing ERR?

Or just no power and nothing works?

Hi I'm having the same problem!!!
My Nikon D5100 camera giving a sin of Autoexposure error after it's drooped from my tripod on the deck floor (Wooden Floor). How can I fix that? I tried few does not work, please help me, it's an emergency. Thanks!

Test ur tv remote control first see,if it is working,malfuctions or completely dead?U have a Digital Camer wright?Yes.Digital Camera can read Infer Red signal Output by the tv remote.Yes?Turn the Digital Camera on and take the tv remote point it at the Digital camer and pushes all the remote buttons the Infer Red signal will read all buttons Infer Red signal flashes u can see on Digital Camer viewing screen.Pushes all remote buttons see flashes of white lights.Mean the tv remote control it it good or not.Take some cottons ball soak it with some rubbing alchachol clean the tv Infered Red sensor on the tv frame near the power LED incation light.Might be dirty,Still not reading the Infer Red signal.If 100% it is the tv remote control is the cause,it CPU is dead.Try website like Remotes.com to buy another the tv original remote.

your battery in camers is going bad replace.

The built in flash's autopop up is not working

hi to get drivers for packard bell is very difficult. i advise you use a 3rd party software like driver genius to help you find the drivers as it detects it from the board

Hi,

Remove the battery and tap the camcoder a few times on the left side and bottom.

The error will go off and your cameral will start working !.

Change the flash settings to the lightning symbol.

You don't have to. Just gently smack it a couple of times. I swear, it soounds strange but it works!!