Why rac 2000 power wash not pumping - Northstar Pressure Washer 3000 PSI

Indicates the pump not producing enough,in park rev the engine to say 1200 rpm and see if it acts the same as 20mph turn steering at same time.

Jack the truck up and see if it's hard to turn . Now if you did nor flush power steering system the pump could have gone bad . Most power steering pumps carry a warranty on them wouldn't hurt to swap it out he can do the work yourself but it sounds like your rack and pinion is starting to fail

ROUTE 66 - RAC satellite navigation devices

tw2.ro.66.com/rac/index.php?cid=UK
RAC Sat Nav 515F ... If your RAC Sat Nav develops a fault in the first instance contact the RAC Sat Nav ... If you have any questions about using your RAC Sat Nav please call on 01302 ... ROUTE 66 Navigate 7 - User manual - SW (499KB). ROUTE 66 RAC satellite navigation devices

It offers a PDF to download or read online.

in the tank

your problem is either in the steering gear(rac and pinion) or in the power steering pump

bad pump, bad tie
rod ends, bad balljoints ,bad rac and pinon!!!!!!!

That was a sign you need a fuel pump.. What a tech will do is check to make sure you have power and ground at the fuel pump., if you do and you have no fuel pressure then the pump is bad. If you dont then he will have to figure out why the pump is not receiving

Hello, I am going to make a few assumptions here. The vehicle has an electric fuel pump and you replaced it. The vehicle has fuel injection. The engine is actually cranking, just not starting, when you say "car still won't crank". You are getting fire to the spark plugs at the plug ends. You checked the fuel pump for power at the pump. No power, then you back traced the wire to the fuse block and checked the fuse to see if it was blown. If the fuse is good back trace the power to the ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel manifold for pressure. No pressure, check the fuel filter for blockage, or replace it. Fuel pump doesn't run, new replacement pump is defective. There is usually some type of control module for the fuel pump on fuel injected vehicles. Good Luck, RAC

look at the starter relay and fuses and power coning aut of the ignishion