Washer doesn't spin, just makes funny noise.

possible belt rubbing or motor noise

Needs agitator dogs in agitator.

It sounds like your water pump is broken. there is a motor inside that pumps the water out when the machine computer changes to spin cycle

this is probably a bad motor coupling, you have to take the cabinet off, then the drain pump, then the motor, the coupling is located between the motor and the trans

You have a broke motor coupling broken between the motor and transmission the part is not expencive but a little hard to explain how to put it in.

open top cover (two or three screws on rear and slide back) and look at rear of tub checking clearance to rear panel and nothing touching belt or pulley. whirlpools tend to have a high pitch low volume whine anytime motor operates.
you really dont want to replace that bearing. part of tub assm. $400 part plus labor

bad motor most likely. easy fix

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Pr obably a coupling between the motor and gear box, Take motor off and coupling will come out, re place it and it should be fine

coupling.between motor and gearcase.

sounds like water may be going out but no spin in last cycle lean washer back and ck underneath for oil leak on top off transmission is a silver colored disk shaped object this is part of clutch if there appears to be a lot of oil on it good chance there is oil on clutch also causing it not yo spin..also ck to see if basket spins after short pause at end of rinse cycle ..start a rinse cycle at setting on timer with lid shut allow to run undisturbed ..once agitation stops in rinse timer should stop then start motor back up to drain ..there should be another short pause then washer should start spinning if does not pause suspect suspect timer if it does pause but doesn't start spinning suspect transmission..remember allow washer to advance by itself DO NOT RAISE LID TO CK..a small load of clothes will let you know if washer has spun