Question about Washing Machines
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
with my wt965a hotpoint ultima lcd fault code f 18 it was a reverse polarity on the main electric board of the house which means live & neutral are the wrong way round good luk dekka2
Posted on May 20, 2008
SOURCE: Bosh Washing Machine F18 fault
I also had this problem - the machine was full of water and it flashed up F18. I had to drain the water out of the machine using the small pipe located next to the drain filter. There was loads of water to drain out. I used my oven roasting tray which was perfect for the job. Then I undid the screwcap filter. There was a lot of really black water that came out, along with about two pounds worth of coins and some hairgrips. Now my machine works perfectly !
Posted on Oct 11, 2008
SOURCE: washing machine wont rinse or
I just fixed my machine through this site, it means the drainage hose is blocked.
The small access door at the front has a hose and a small screw cap. I drained the water via the hose then undone the screw cap and found it was blocked by tissue.
Put everything back and now is working.
Posted on Jan 28, 2009
Open the small flap at the front bottom right of the machine. DONT unscrew the circular white knob yet!!! Use the small black hose to drain the machine into a tray, by removing the small cap on the end of the hose. You will have to use a tray, rather than a bowl because the hose is only short, and keep emptying the tray.(put a washing up bowl next to the machine, so you don't have to carry the tray.) If water does not come out of the hose, then gently unblock it with a piece of wire or fine knitting needle. When water finally stops coming out of the hose, it is time to gently unscrew the white knob anti-clockwise, and pull it forwards. Now you can clear the debris out of the pump rotor, which is behind the white knob. Check with your finger that it can rotate freely, then replace the white knob firmly. Make sure the small cap is replaced on the end of the hose, clip it back into place and put back the cover panel. If this doesn't work then there is a blockage deeper in the machine, and dismantling will be required. Good Luck!!
Posted on Dec 24, 2009
Tips for a great answer:
Mar 26, 2017 | The Computers & Internet
May 14, 2011 | Bosch Axxis+ WFR 2460 Front Load Washer
Jan 06, 2011 | Bosch Exxcel WFX 2467 Front Load Washer
Dec 31, 2010 | Washing Machines
Aug 23, 2009 | Bosch Washing Machines
Sep 01, 2008 | Bosch Logixx WFT 2806 Front Load...
Feb 03, 2008 | Bosch Logixx WFT 2806 Front Load...
384 people viewed this question
Usually answered in minutes!