Hp 2055 out put bin error fixing - Lexmark E450dn Laser Printer

https://h30434.www3.hp.com/t5/LaserJet-Printing/Won-t-print-error-msg-about-the-output-bin-is-full/td-p/6208665

https://support.hp.com/au-en/document/c01948565

https://www.technibble.com/forums/threads/output-bin-is-full-hp-laserjet-p2055d-printer-error-message.17914/

Check the flag that hangs down as the paper is exiting printer.... sometimes the flag gets stuck in the up position..(causing the printer to think there's a big stack of paper needed to be taken off the machine...found this from another fixya member.

If you have already removed the paper from the output bin, check the delivery flaps to make sure they move freely. If they do, remove the top and make sure the sensor flag isn't broken and that the sensor is connected and undamaged. If it is connected and undamaged, check connector J213 on the engine controller is seated correctly. If it is, you probably need to replace the output bin sensor. See attached video

The correct solution is to replace the scanner with the correct M401 model not one from an older HP. The scan speeds could be different, the motors could be different which would make the formatter think that the motor was turning too slow.

there is a small flag sensor in the output tray over the roller that deliver the printed paper , its not return down after paper get out. so the the printer scene the tray is full , check it may lost if not try to lubricate the support pour it hasn't spring it move to its weight. or it may

i have hp laserjet 2055 error 84 1d31 .,
how to solve this error,?
What is the posible cause when this problem or error
comes,.,

hello for all my dear the problem in hp lj 2055 install black cartridge error massege here the solve iam engineer in hp service center and i meet that problem in my daily work the problem in dc control must t replaced sure 100%

hi

regarding your error go to following link

http://www.copytechnet.com/forums/xerox/36062-xerox-docucentre-ii-2055-error-016-315-a.html

check the flag that hangs down as the paper is exiting printer.... sometimes the flag gets stuck in the up position..(causing the printer to think there's a big stack of paper needed to be taken off the machine

This is an error when it senses there are too many pages that have been printed and are sitting in the bin.

Take a close look at the flaps hanging out the exit for the printer. They should move up and down freely. If one of them is stuck up, broken or dislodged, you'll get the bin full error. The flaps on the other end (side you can't see) have little flags that sweep between photo sensors and tell the printer in the tray is full and if paper has exited the printer into the tray