Podhd400 not working - Line 6 POD HD400 Pedal Multi-FX Guitar

Joewalter 68,
If the clock with batteries it must work with 9v. First check the output voltage with multi meter, of the adapter if it shows it will works, also check use correct socket then it will works. it will works.
with regards,
jaijith

We sell this Same PA at the music store I work at,
and I know that Any normally open momentary switch will work
if it's Not working, then either the switch or cord is defective
or we have had to service a few of these, never for that problem tho? So I guess it could be the input jack on the PA ?
Hope that Helps?

does the speaker still work? use a 9 volt battery and do a test thump to see if the horn and woofer still work...when the power amps on these units fail most of the time they shut down.

Then you either have a blown amp or speaker. Turn the amp off and move the wires from the speaker on the working side to the other speaker. If the other speaker works, you have a dead amp channel. if it does not, move the wires from the speaker on the non-working side to the other speaker. If that works, you have a dead speaker. Dead amp channel means take it to the shop. Dead speaker means buy a new one from Line 6 and install.

Either your key scanning section or the power amplifier has fried.
Try playing the demo song, if the sound can be heard then the scanning section is faulty. You may download the servicemanual from Elektrotanya com and repair the keyboard.

Hi there,

Well you may follow the link below to get your manual -

http://cachepe.zzounds.com/media/Line6PodHD400QuickStart-12fd8b27f633e744690f694ab6a375fc.pdf

Good Luck!!

Thanks for using FixYa!!

What type instrument is it? Yamaha makes a bunch of different ones. Specify a mdel number.

Either the keyboard is disconnected or the Keyscan on the keyboard itself is but. More than likely a loose connector.