How to fix black color too light? - HP LaserJet CP1515n Printer

Left light
Pink/black tail light
green/yellow stop light
grey/bue turn
black ground
Right
pink/black tail
green/yellow stop
grey/red turn
black ground

No. Black will be much warmer than white or a light colour. Black absorbs heat, white reflects it, so it is much cooler to wear white in the sun.

Is the light printing the same for black and white vs color? Light printing on a side is not uncommon for these printers. It is usually caused by the laser optics getting dirty. But this usually shows up more in one color than the other. Such as something printed in yellow is fine while red is faded on one side. If the light on the right side printing is the same on all colors including black then I would suspect something with your transfer unit.
If you do notice that it us just on black or another color then it is definately time to get the laser optics cleaned.

Please check your printer setup. from the document you are printing. Choose the printer from the FILE menu (depending on what program you are running) Printer SEtup or Properties, somewhere you will find an option, Print in color? or Black, Click on the Black., come out of the menu and then print, I am pretty sure you have chosen color.
Hope this will fix your problem.

brown would be the parking light hot wire
green / white would be the blinker hot wire
black yes ground ,
but according to the schematics , **** this color combination only applies to the left front

the right front should be :
brown would be the parking light hot wire
black ground , and a white / light blue would be the blinker hot wire

do you need the rear colors ?

brown is parking on both left and right rears
black is ground on both
light green / orange left blinker / stop light hot wire
orange / light blue right blinker / stop light hot wire

J5

My HP Deskjet 6940 is not printing. The color (left) low ink light is dark and the black (right) low ink light is flashing. I replaced the black ink cartridge with a new one but the low ink light continues to flash. No tears/rips in the circuit strip and all the copper leads appear to be connected

Yes, this printer has fixed printheads and must have ink in each color to prevent damage to the printheads. Even when printing black only each color is spit in the servicing area to keep the printhead unclogged.

Regards,
Bob Headrick, Microsoft MVP Printing/Imaging

not sure w/ this one, but is it blinking too fast on printer, the check color and black ink cartridges? and if yes what is the color of the light, is it yellow or red, and is the on and off lights, flashing?
-black and color blinking fast - install printhead
-black and color blinking slow - no cartridges installed
-on and off blinking black and color steady lights, calibrate

-hope this helps, or else contact kodak
-xoxo

You can only print in BW or Color.


You still need both cartridges...

sorry the problem is internal the color ic needs to be change,contact your tv repair technician