How to disconnect beeping hotpoint stove digital timer/clock?

Hi David,
I am not familiar with this kind of stove, but most of the clocks work the same.

NB, before doing this, unplug the stove.

There is one wire that feeds the clock/timer (this wire is often red). And there is a 0-wire (this one is often blue)
When disconnecting that (red) phase wire, the clock will not run anymore, but neither does the oven.
On the clock must be 1 more wire and that goes to the oven. May be this wire is brown.
Just make a connection with the (red) phase wire and the (brown) wire that goes to the oven.
Then the oven will work again but the clock is out of order.

I hope this helps, Kind regards, Dik

Clock & Main control display issues - YouTube

? 4:44
https://www.youtube.com/watch?v=OmOocInxHOo
Jun 28, 2013 - Uploaded by ApplianceVideo.com
... symptoms: Clock and display does not work At: http://www.appliancevideo.com For ... and show you how to ...

Range/Stove/Oven Repair - Replacing the Clock Timer ...

? 3:42
https://www.youtube.com/watch?v=0RSnf4wfSZM
Oct 20, 2011 - Uploaded by PartSelect
Range/Stove/Oven Repair - Replacing the Clock Timer (Frigidaire Part .... My timer still works fine, but ...

Y0315570 Amana Range/Stove/Oven - Appliance Timer

If you disconnect it, you will loose functions to the oven so you will need to replace the clock/control board. Here is the part to order.

Hello,

The beeping indicates to me that the clock has power to it and it's the problem and needs to be replaced. ya need model number to order part it usually can be found on rim around door or inside of the bottom storage drawer, when ordering parts its call by 4 names, all are the same part its either clock, eoc,oven control,or relay board

Gene

Hello there schematics for your unit will be next to impossible to find on the internet. My guess is that your unit uses a manual type timer as units that old usually have the timer independent of the other functions of the unit.therefore you wont be able to find any wires which power the unit. Mostly the timer will run on its own as a result of sensors on the unit. Both options which you have considered are gud but lubricating the bearings seems more likely although getting at it might be a bit difficult what you need is a watch expert usually they have methods of loosing out the entire clock mechanism taking it for servicing and fixing it back on your unit this way the bearing noise will stop. Also if you decide to take of the clock completely the same procedure applies.
Hope this solution has been helpful?

3 instances of this problem and no fix?

Maytag Range / Stove / Oven Fault Codes Failure Code Fault Code Description Solution F0 Function key stuck Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). F1 Defective touch pad or clock (ERC) Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more information. F2 Oven temperature too hot Replace relay board, if present, or oven temperature sensor (RTD). Check sensor harness. F3
or
F4 Shorted or open oven temperature sensor (RTD) Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok. F5 Watchdog and hardware conflict Replace clock (ERC). F7 Function key shorted or stuck Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). F8 Analog / Digital problem Replace clock (ERC). F9 Door latch Check door latch components.

Replace the oven control module.It controls the bake and broil including clock and timer functions.

push in on the center one I think