I need to remove the seat cover to wash but i jus canny do it the seat belts are in the way please help
Peel the cover from around the seat frame so that the shoulder strap hold the cover on to the seat. Extend the set belts to their maximum length and recline the seat as far as possible. Looking at the seat from the front, put your hand in the gap between the reat of the seat (bit that reclines) and the fromt of the fixed base (by the red dome and the instructions). On the bit of the seat that reclines there is a 'door' that opens to reveal a metal clasp that the ends of the shoulder straps fix to at the top and the **** belt at the bottom. Unhook the looks from the shoulder straps from the metal clasp. Pull the shoulder straps through the back of the seat upright. You can now pull them through the cover which is free for you to was. A great design hey ! Good Luck.
The belt guard door is shown on the attached diagram.
http://www.maxi-cosi.com/media/productha...
this was very helpful, thanks 4 taking da time 2 add this,xx
×
To be able to remove the seat cover from your seat you have to 'unhook' the seat belts at the back of the seat:
First extend the seat belt to the maximum length.
Then put the seat at the maximum recline.
At the back of the seat-'shell' you will then see a metal hook that hold the shoulder straps: unhook and pull forward.
Reassembly is just the reverse.
A few more tips when removing the cover from a PrioriFix: take care not to damage the white extruded foam when pulling the belts forward and when taking off the cover. When the foam is not protected by the padding it may easily snap.
The seat padding is cold wash only and no spin-dry, otherwise the seams may loosen.
Please don't hesitate to use the contact form at http://www.babycare.nl if you need any further assistance.
With kind regards,
Babycare.nl Sales Desk,
Erwin de Raad
2,594 views
Usually answered in minutes!
×