205swan secura view Gw205 wiring diagram broke power plug from monitor

It is unlikely you will find a wiring diagram for an old model. It should be a simple wiring where the plug wires split and one goes to a switch and then from the switch a wire goes to the motor. The other plug wire goes to the motor. The unit probably doesn't have a polarized plug, so no need to know which side of the plug wire goes to the switch and which goes to the motor.

http://harmonyflutes.com/wire/vga-cable-wiring-diagram

http://www.darren-criss.org/vga-wiring-diagram/vga-cable-wiring-diagram-c0a4d90d05ff246d.html

most likely vga cable

which type of wiring diagram do you want.
do you want to deploy the Camera or the wires have been just ripped.

how to wire it , the motor plugs right in, there is a connector for the wiring .i will see if i can give you a wiring diagram, lets see......okay here is the wiring diagram for your 1994 toyota camry, hope this is helpful, good day....

Sorry but we have no wiring diagrams.

hi have the same issue found it to be red power black negative yellow video white audio and bare wire is the shared ground for the yellow and white hope this helps

facing the rear of the monitor, the two round 5 pin plugs on the left are the rear camera plugs on the far right four pin square plug red cable terminal 15 ign power... black cable terminal 31 neg battery... orange cable back-up lights... white cable to hopper lights.., I have a full wiring diagram for the system if you needa copy e-mail me at [email protected]

I have the same speaker set. maybe we can help each other. My plugs are all fine but my sub is not connected to anything at all and I need to know were they must go on the pc board. Maybe we can trade some photos on the wiring diagram?

Helpful Wiring Information when hard wiring your brake control:
Run two wires to the battery:
White - Ground
Black - Power
Blue - Run to Electric Brakes at the Rear Plug
Red - Run to cold side of brake switch off of the brake pedal (using a test light to find the cold side)
Note: Always wire the red wire to the heaviest gauge wire when testing cold side of brake switch.

You can view more info here. http://store.drawtite.com/brakecontrols.html

hi on what you have just told us go and get the same cables that you were using in the old car coz this wires are the ones ment for the screen i mean right holms,right jack pins for it . good luck .