Ce code error

Download the newer version,
https://futura-ce-350-software.software.informer.com/3.0/

PS4 error CE-34878-0 occurred occasionally to users. Don't worry, though! It's not difficult to fix. We're giving some troubleshooting steps here to help. For steps : https://www.errorcodeexpert.com/how-to-fix-ps4-error-code-ce-34878-0/

According to page 21 of the owner's manual, the following are known error codes: IE= Water Inlet Error, OE=Drain Error, UE=Unbalance Error, dE=Door Error, tE=Thermistor Error, FE=Overfill due to Faulty Water Valve, PE=Water Level Sensor Error, CE and LE=different Motor Errors, and PF=Power Failure.


its a motor error
check the brushes

What were you doing or trying to do when you got this error code?

Code "CE" stands for communication error and describes a fault between the mother board and the display. I doubt it's the relay causing it though...

the ce-02 code is just a communication error it general in nature so you could have a couple different issues going on

CE means communications error

If there is any breakdown in communication between the machine controller and the motor controller, "CE" flashes and the unit beeps once.
Some common causes of "CE" errors include:
·Conformal coating on serial communications pins between the machine controller and motor controller. After disconnecting power to the unit, try scraping this coating off the pins.
· Check the resistance values between the serial communications pins with the connectors in place. Make sure the harness does not have a bad connection.
· Check the quick disconnect at the motor terminal. The drive motor must be hooked up properly or a "CE" error will occur.
· Drive motor thermal protector has opened.
·Motor controller is not powered or fuse has opened. Replace motor controller.

Press STOP/CANCEL to clear the display.

http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%203955179.pdf

manual

“CE” (Communications Error) flashes - beeps once
Press STOP/CANCEL to clear the display

ce is communication error could be a bad connection between the 2 boards.( i doubt that) or the drive motor protection open. or the motor controller is bad. there is a notn replacable fuse on some of thos boards. check to see if it is open. Make sure you unplug machine.if it is open replace motor control board. Part #8541034