My fridgiaire frontload 7000 will not heat - Frigidaire AEQ7000ES Dryer

The vent might be clogged or the heating element could be broken or is having issues and needs replacement or the cycling thermostat is bad. You should get your dryer repaired from someone that repairs major appliances.

freezing gas is over ,, some company offer to refill it

Hi,
There can be a few reasons why an electric dryer does not heat...

Check out this tip that I wrote... it will help you find the thing that is causing your problem..


http://www.fixya.com/support/r3866345-dryer_troubleshooting_electric_dryer_won

heatman101

Hi,
Most gas dryer no heats are cuased by a faulty ignitor...
Check out this tip that I wrote about your problem...

http://www.fixya.com/support/r4398592-gas_dryer_not_working_gas_dryer_not

heatman101

i think that first u should detach its easily detachable parts and then for instant dry ,dry it with heat blower, and put whole parts in sun light...if not works then take away to the technician for preventing major loss

Hi,

If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.

if you dryer is gas check out this gas no heat tip....

If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.

check out this electric no heat tip...

heatman101

Not sure of error message try clearing the pump or filter

If you have a access to an AC voltmeter, measure the two slanted connections in the wall socket for ~220 volts. If near zero, measure at the load side of the dual breakers for the same voltage. If still at or near zero, one of the breakers has gone south. Replace the pair of breakers.
If you measured 220 volts as above, then the problem is within the dryer--probably a burned out heating element or open thermal fuse. Major tear-down to find and fix as the heating element is behind the drum.

needs a new temperature sensor

Error code ## 322 indicates that the Fuser not heating (Usually cause by a Bad Fuser Module)