Hcm 582 monitor not display show - Acer AC713 17" CRT Monitor

Contact Pogo Technical Support at +1 302- 857- 0786

#PogoSupport
#pogosupport
#pogotechnicalsupport
#pogocustomercare
#pogocontactnumber

We do not sell or have listing for these.

old post,,,, but others might find it useful.
in the fuse box. on all suzu.
see oper, guide for fuse info see if it show the relays
some guides, shows them as blank.
that means , its covered in FSM... factor. serv. man.
did you even look on both boxes both have labels....>????
blower fail on high?
is the fuse good, that is first not relays

this car has a HVAC control module HCM.
so the blower works in this path
fuse, > relay, >> blower power transistor module>>> HCM
the HCM inputs must be correct or i will not turn on the BPTM.
4 fuses, related. min.
and sensor inputs.

did you try a scan tool yet
to see if there ARE HCM DTC errors


location of relay
the relay is in TIPM box 2
grengo for , fuse box 2.

location 19
bottom right relay
seen here.

Is there a light on the monitor when it is plugged in and switched on?

If no light:-
Ensure the power point is fine by plugging something else in you know works.
Try replacing the power lead to the monitor.
If there is a light:-
It could be the switch, which would require opening the monitor and checking with a multimeter.
Failing that it's probably the power circuit inside the monitor. Unfortunately I don't have one, so I can't give you much more information beyond that.

This CRT monitor has a fault in the horizontal deflection circuit. It is not worth repairing, I suggest you put money towards a new LCD monitor, these monitors are not expensive.

Try disconnecting the monitor from the video connection.
Disconnect the power source and allow to set for several minutes.
Plug in the power source only and see if you recv. a no signal message on screen.
If not, you most likely have a bad display board or back light problem.
If you do recv. the message, you have a problem with your video card.

Sir,

u must install a small software for detecting the sound card name, serial no. etc.... download from this link and install it. After installing it open a html page which shows ur history of your computer. it is a free personal audit of your computer. Try it and let me know it is useful or not....


Thanks
Good Luck

"Appreciate to rate as FIXYA"

dry soldring at crt neak card