Aastra 9120 call forwarding

www.aastrausa.com

were you able to get this working? hat did you have to do?

In order to set call forwarding on this telephone, must first have the feature CFV (Call Forward Variable) on in the line. This feature can be provided by the telephone service provider.

A typical feature code for this is *72 to activate CFV and *73 to deactivate.

You can program these features on the M9316 telephone by do the following:

CFV activate

1) Press the SAVE key.
2) Then select the key where you want to program the feature.
3) Then enter *72 (optional: plus the telephone number of where you want the call to forward to).
4) Press SAVE twice.

CFV deactivate

1) Press the SAVE key
2) Then select another key where you want to program the feature.
3) Then enter *73
4) Press SAVE twice.

Be sure and label your buttons.

To use go off hook and press the key you just programmed.

i have the same issue. considering the following solution; install a splitter to connect both phone ports to a single line.

If your phone company provides the service, you should have a code to enter. If YOUR telephone switch is doing the forwarding, you will also have a code to enter.

Basically, you enter the code, then dial the number and hang up. To unforward, you dial a similar code, and hang up the phone.

Forwarding is through the plan provider and part of the voice mail system.

No, the M7208 is a propriatary set which requires the PBX to function, whereas the aastra phone is a stand alone set which requires a standard telephone line and a power source.

http://www.retrevo.com/d/ds/progress?doc=67ab324793d14f7027c630962ba726f8

Ok, this is your manual .I searched for "call forward" and this should help.

Turn phone upside down and look for a little ***** switch that says 1 -- 2 -- 1+2 and slide it to the "1" position.

I think forwarding is in your PBX rather than the phone.
On my system it is #1+ext to forward and #1 to cancel.