Replacing igniter on a sgs36g

Question edited to add maker.
Question moved to correct category.

Dacor only shows the parts layout.
https://www.guaranteedparts.com/picture_library/Dacor/Cooktops/PM_ESG_051410.pdf

Normally, you remove burners and shrouds and then look for screws at the front that secure the top panel. When you lift that up, the ignitor and wires are visible.

https://www.google.com/search?q=Dacor+Epicure.+ESG366SCH+replace+igniter+leads

..

The link below shows the different parts for that unit. There is a button under the items that says watch video.
http://www.appliancepartspros.com/search.aspx?model=cvg4380

How do I lite a whirlpool electric gas stove?

see this steps and fix it. God bless yo
Relight an oven pilot:

1. Turn all controls off, open the doors, and allow gas to dissipate.
2. Hold a lighted match near the tip of the pilot on the burner assembly. If a burner does not light within two minutes, adjust the pilot, step 3.
3. Turn the pilot adjustment screw (located near the pilot or the thermostat) in small increments and retest until the pilot has a blue flame.
4. Check and replace an oven spark igniter:
   
5. Turn all of the appliance controls off.
6. Open the door and remove the oven bottom and the baffle (see above).
7. Unscrew the igniter from its mounting bracket and inspect it for cracks or other defects. Replace it if it is damaged.
8. To replace a faulty igniter, find the ignition control module, unscrew the cover, and disconnect the module. Install the replacement part and test.

no not standard. but you can replace them if you know a good place to buy high temp wires. If not buy the upper wire harness for the range and the igniter wires will be in that.

I have a stove that doesn't light (click) I've replaced the igniters, I've replaced the knobs, and I've replace the box all the igniters and plugged into. There's nothing else to change out and it still doesn't give a spark. I've got gas and electricity but nothing will light

u nid the serviceman to replace the ignition coil,coz its hard to replace & expensive the parts,temporary use macth

if u push the knob there is a clicking sound, if no the problem is damage the ignition coil, need to replace it,or check the outlet,plug or its batery operatet ignition? replace the batery.
the ignition is power operated,check the power source.

tnx gerbee

Check to make sure that the gas is getting to the igniter. If you can ignite with a lighter or match, than the igniter itself needs to be replaced.

The problem here is that the port holes in the burners are probably clogged. Clean ALL burners by taking a toothpick and unclogging the port holes. As for the position problem, if you have independant igniters, as some models do, you may need to replace the igniter. Remove knob and remove igniter,(white rectangular item with two wires) remove wires and replace.