Need a replacement 6v battery for a dorel quad

All you have to do is Google "assemble chad valley quad" to find videos. One of these should work:
Redman and Associates 12V Quad Bike Assembly
6v Large Quad Bike assembly instructions

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

If under warranty have it repaired/replaced. If not under warranty then some basic troubleshooting. Most likely a battery issue howerver;


To test the fencer output you can power the fencer from either a standard 6V lantern battery (6V fencer) or a standard 12V automobile battery (12V fencer). You need to rig wiring observing polarity.


To test battery, remove and check voltage with digital volt meter.
A fully charged 6V SLA battery should read 6.2V minimum and a 12V should read 12.4V minimum. If a 6V battery measures 4 volts or less then battery has likely failed. Likewise if a 12V battery measures 10 volts or less it has likely failed. Before replacing a suspect failed battery, connect the battery to any standard 6V/12V automobile charger and see if it will take a charge. After the charging period;

• If battery takes a charge, reinstall back in fencer and see if fencer output is hot. If fencer fails output, repair/replace fencer. Else verify the fencer is charging the battery. While battery is installed in fencer measure battery voltage with a digital volt meter. Typical minimum voltage is 13.5V for 12V and 6.7V for 6V. If fencer fails to meet minimum battery charging voltage, likely the fencer solar charging system has failed, repair/replace.

• If battery fails to charge, likely battery is end of life. However fencer could still not work. Test fencer with alternate power source (see previous tests). If fencer ok, replace battery.

I have 6v chargers with alligator clips on the end that work, you'll just have to remove the plastic battery cover (6 screws) so that you can clip it onto the battery

you can get aftermarket ones for about $10, but any 6v 1a sla battery charger should work

check the sharger with a multimeter to make sure that its putting out enough volts, Is it a 6v or 12v quad, also i've seen alot of peg perego batteries where the wires on the battery itself have come disconnected under the plastic housing, you can use an auto body panel trim removal tool to pop the plastic piece on one side of the battery to check and see if the wires are connected

Here's the manual, which includes instructions:

http://www.toyservicecenter.com/Model/View/T5003-Toy-Story-Lil-Quad/413-0-0.aspx

Please visit:-www.alldatasheet.com its free And just a tip anything you do take a pic on ya mob then you can go back to for reference,hope i helped i have a scooter myself Colin.

You should have a battery charger to charge the 6v battery that powers the wheels, your first step should be to make sure this battery is fully charged, its located in a compartment under the seat.

You need a 6v lead acid battery with 4.5ah, available from maplins for £5.99 (13/11/10)