Have error code fi-e3 - Whirlpool RBS245PDS Electric Single Oven

F1 - E0 EEPROM communication error 1. Disconnect power for at least 30 seconds.
2. Re-apply power and observe for at least one minute.
3. If code re-appears, replace control board (also called ERC or clock).

Note: Applies to all F1-E... codes except F1-E3. F1 - E1 EEPROM checksum error F1 - E2 UL A/D error(s) F1 - E4 Model ID error F1 - E5 Calibration shifted F1 - E6 Latch signal mismatch error F1 - E9 Stack overflow F1 - E3 Wiring harness cavity size does not match previously stored value The "Cavity Size Select" jumpers in the wiring harness indicate a cavity size different from that which the control was previously configured for. Check the jumpers in the harness to make sure they agree with the actual oven size.

This error means your temperature sensor (probe) has failed and needs to be replaced.

Technical sheet says all F1 codes to replace control

What error code
was it
E1
E2
E3
E?????

Different error codes mean different things

Hello & Welcome to FixYa

F2-E3 error means open/shorted oven temperature sensor and to solve this problem the sensor needs replacement. If you want to do it yourself and wan to be sure before replacing the sensor then you can test it with a voltmeter between 1080-1120ohms....if it reads more then or less then this then it needs replacement however, if the reading is around between 1080-1120ohms then it is the control board that needs replacement. Please get back to me if you have any other questions.

Kevin

Thank you for using FixYa. F1 refers ro a fault with either the control board or touch pad. Both may need replacing to clear this error. E3 refers to a fault with the temperature sensor and should be replaced. This unless the repair done by yourself may work out expensive.

Sorry to be the bearer of bad news.

Hello,the error codes E3 and F1 means Wiring harness cavity size does not match previous stored valued
SOLUTION:The "Cavity Size Select"jumpers in the wiring harness indicate a cavity size different from that which the control was previously configured for.
Check the jumpers in the harness to make sure they agree with the actual oven size.
Thanks

Kitchen Aid Error Code F2-E3

Called kitchen aid, they said you need a new control board part #9782455.

Error E3-F3 says that the Oven temperature is too high(Clean mode).You might have to replace the Oven Temperature Sensor(RTD).

Hi,
I ended up calling a technician to come out and look at it. He said that the front panel where you push all the buttons went out and I would need to get a new panel.