Cannot print to Xerox WorkCentre M128 after upgrading XP to SP3

Kindly provide solution of wavy print in xerox 5755.
Whatsapp 00923334298796

016-315
NUT Interface Fail.
POPO - at least 60 seconds

Hi lambert,

http://www.office.xerox.com/userdoc/P750/resource/750-66.html hear is the Error list please check now.

Here you go:
http://www.support.xerox.com/support/workcentre-m123-m128/downloads/enus.html?operatingSystem=win7

http://www.support.xerox.com/support/workcentre-4118/downloads/enus.html

The above links to the drivers page, but unfortunately, I do not see specific Windows 7 drivers for this printer. This means that older XP or the latest drivers from the year 2008 are used in emulation mode, maybe, for Windows 7.

Since this is not a 'new' printer, I gather, it will not guaranteed to work with Windows 7. However, I would try the link above for various drivers which may or may not work on this printer.

The fact that the Printer is shown to be offline, is a bad sign.
I read that the printer in question has the following connectivity:

Connectivity

But, that it doesn't support WiFi.


USB, Parallel, optional 10/100 BaseT Ethernet.

Log in as administrator. Press "key" button and enter pass code 1111. You will find the settings quite easily and can change them.

This error code means the Scanner is not installed. The reason for this code could be a bad or diconnected interface cable, or corrupt system software. Check the cables for connectivity. If the problem persists, it will probably require a call to Xerox service. 800-821-2797

DNS errors then? can you map to the printer via hostname too? Are you sure you're not using SP3? When we upgraded to SP3, we had to use the new drivers. Try new drivers.Have you tried just rebuilding your print server? try sharing the printer off your computer in the data center and try t print to that. When you ping the data center from the user's computer... what is the delay?

i changed the usb cable to anthor one Parallel Port
Cable so i think the adapter of usb cable is damaged so now it work.

There is an error in the in the server password or a template setting.
Here is the documentation. Pretty straight forward

Login to the Server was not possible during Scan to Server file transfer.
Initial Action Refer to BSD 16.1.
Power OFF/ON
Procedure Set the login name and password in the destination server.
Set the attributes of the Job Template file correctly.
From a client PC, set the same account as the above as a resource using CW.