Upper output been full - Minolta QMS PagePro 9100 Laser Printer

Please tell me the model no.

Probably just a bad sensor or dirty sensor causing the issue.

Stacker or stacker/stapler output bins

For the 3,000-sheet stacker or 3,000-sheet stacker/stapler, the output bins are the upper bin (face-up) and the lower bin (face-down).

The upper bin (face-up) is the top bin on the stacker or stacker/stapler. This bin holds up to 100 sheets of paper in face-up order as they exit the printer. A sensor causes the product to stop when the bin is full. Product operation continues when you empty or reduce the amount of paper in the bin.

Lower bin (face-down) is the lower bin on the stacker or stacker/stapler. This bin holds up to 500 sheets of paper and can stack or staple jobs. This bin is the default output bin.

Upper Left-Left Front Output

• Upper Middle-Right Front Output

• Upper Right-Rear Output

• Lower Left-Master Cylinder Secondary/Front Input

• Lower Right-Master Cylinder Primary/Front Input

After print paper reaches upper bin, you can observe a flag moving while paper coming out. once this flag is stopped moving printer treates bin full..check the flag is moving freely. open top cover clean this sensor.

You cannot swap upper and lower images. You can scan the page twice (in duplex mode) by reversing the same. Ensure which side is giving perfect output.
DR 7580 is a CONTACT scanner and hence the paper has to touch the glass surface properly. There are two full sized rollers, just above/below the scanning module, which does this job. Ensure that they are proper and there is enough pressure, press and release 3-4 times to check it is stuck.
S. Mohan, Chennai, India

check the sensor. for the upper output pin. it mite need to be replaced.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

check the sensor it mite be dirty

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

FORMAT->>on the left in upper corner chose compress pictures, click on it window will pup up, chose what you like in target output. And that is it.

I used the Optra W810 driver. It had listing for *UPPER and *LOWER for the bins....

So..I took a chance on the following


Output Bin
Sel Cmd Description
1 3 Output Bin 1
2 4 Output Bin 2
*LOWER 2 Lower Output Bin
*UPPER 1 Upper Output Bin
3 5 Output Bin 3

All is goo!

hi im jules_09,there must be a small piece of paper stocked at the output tray.see if you can open the front door then full out the fusing unit somtimes paper is stocked in it.then while the fuser or fusing unit is out check the output tray if there is a paper.in the fuser unit check the hotroller or upper roller its a black metal roller that heats up