Tallyerp 9 memory access violation

If there are any user defined TDLs defined in the Tally.ini file set Default Companies to NO start Tally and check.

If the problem persists
Increase the screen resolutions to 16 bit high color small fonts, Load Tally and check.

If the problem persists
Delete the printer drivers available in the Printer panel. Execute Tally. If this resolves the issue you can then re-install the printer drivers.

If the difficulty persists
After checking above-mentioned in case the difficulty persists please check the following.

Check for viruses in the system
Delete the Tally.sav file and check
Re-install Tally in a different folder and check
Disable the real time protection of the Anti Virus Software

Incase the problem persists please send an email to [email protected] .

In case the problem is rectified when Default Companies is set to No in Tally.ini it indicates that the default company is corrupted. In such cases please follow the steps mentioned below

Take a backup of your company data
Execute Tally 9
From the Company Info Menu press Ctrl Alt R.
The Rewrite company screen is displayed. From the List of Companies screen select the Company in which you are facing the difficulty. The screen Rewrite Yes or No is displayed. Press Enter to re-write.

The error message indicates a data corruption. Please restore an earlier data backup which did not have this problem and proceed.

If you do not have the Backup then create a copy of the existing data and rewrite it by clicking Ctrl+Alt+R before selecting the Company.

Before rewriting ensure that the Company you wish to rewrite is not in use on any of the nodes and the command has to be applied before selecting the Company.

The data preferably should be available in the local hard disk. Ensure that you create a back up of the data in the the hard disk or a medium like CD.

Check http//www.tally9.info
http//www.tallyerp9.com

I found this howto here: https//answers.yahoo.com/question/index?qid=20100521043632AAsKkQs