T.V. WILL NOT TURN ON.

I put a link some issue which will cause a no start.
I notice you changed the fuse it gives some things to check if the thermal fuse is blown.
https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dryer/1-3--/GE-Dryer-won-t-start

Did you check the dash fuse block? fuse #12?
also maybe the brake fuse.

that item is called a relay switch. it toggles on and off depending on which electrical component it is connecting. if it's blown, they are cheap and easy to replace like a fuse, but you'll need to look at the fuse box chart (usually on the underside of the lid) to determine which one and where it's located. You can't look inside the relay to determine if blown, but you can replace them one at a time to test...
Also, if you're experienced in electrical, a paper clip can be used when the relay is out, to connect the circuit that you need. use tools and or gloves when attempting this method.

It is doubtful but maybe.. Check all the fuses and see if you have a blown fuse. If so replace fuse and see if that fixes your problem.

If you know for a fact the fuse that powers the dash lights is good, you may have cooked the dimmer switch. I would want to check the fuse for power and then the dimmer switch for the dash lights.

Hi, This may sound obvious, but have you checked the fuse? if the machine is completly dead this may be the problem or the ON/OFF switch is faulty. If there is life in the machine the problem could be the door switch. If the fuse has blown then there could be a fault such as heater element blown, is the most common to blow a fuse.

hello!
there is a standard procedure for proper replacement of blown fuse: CRT TVs: unplug degaussing coil, replace blown fuse with 2amp fuse and turn on the set. If it works, reconnect degaussing coil, replace the fuse with correct value(5-8) amp, depends on model(see fuse note next to holder). Enjoy the show! If in a process of replacing the blown fuse with 2amp w/o degaussing coil it blows again, forget about the next step. Set need repair. It could be an easy one, replacing 1 or 2 shorted diodes or bridge rectifier, but could be real piece of work if the power supply got "fried". If your knowledge won't go further, than fuse replacement, I'd recommend local TV repair shop.
good luck,
Alex.

Motor is not turning in second direction to lower window. Either the new motor is defective or the device that reverses the electricity to the motor is defective. Regulator?

Take motor out and feed it juice - will turn. Reverse polarity and it should turn in other direction.

Check the fuses. Under the steering wheel. If the fuse for the dash lights is blown, replace it. If it blows again, replace it again and look into what could cause the short.

The lights may also need to be changed in the dash.

The switch to turn on dash lights might be bad. If this is so, outside running lights won't work either.