Diesel dz4199 setting time - Timex (T307S) Clock Radio

you don't advance a diesel pump
there is a set ignition point for diesel in a diesel engine and any attempt to alter that point results is severe piston failure
if it is not a common rail system, the pump will have multiple injector pipes out the back and there will be an initial timing mark on the gear and then a final timing set by a gauge used by diesel specialist shops pictures are in the workshop manual

comment on the type of engine ( petrol or diesel)
ignition timing for petrol engines is always advanced and most are set between 10 and 12 degrees advanced
with EFI engines the spark timing is controlled by the ECM but it requires an initial advanced setting to start with
really for a mechanic to retard ignition setting I would recommend that you find an accredited mechanic and give this one a miss
if it is a diesel the injector timing is always advanced between 17 and 25 degrees and it is a diesel then the smoking will be unburnt fuel as the combustion process is not complete
again find an accredited diesel specialist shop and have it reset properly

How would you set the timing for the Tata Telcoline 2l Diesel ...

www.fixya.com/cars/t25064504-set_timing_tata_telcoline_2l_diesel
Sep 5, 2014 - After that, you need to bring the injection pump at certain pisition. .... I need help for installing the new timing belt on a 2l diesel engine without ...

put watch in time 1 mode; hold set/el button on bottom left for 2 seconds; use mode button on top right to change between date, hour, minutes, and seconds; use both the right buttons to either go up or down on the different modes; once you have everything set, push the set/el button to save changes

how to set diesel pump timing of OM602 engine?

how do i set my diesel dz7064 in need to set the time

have the same problem

I WILL LIKE TO SET THE TIMEING ON 2002 LANDROVER FREELANDER

hey..i found out how to set the time for the model: diesel dz7087..
all u have to do is press and hold the light button..the when it starts ticking press the mode button repeatedly to set the time,date,etc...when u finished setting everything press the light button and everything will be set..
ciao ciao

I finally figured out how to set the time on this watch! Like others the included manual didn't have instructions for this model.

Hold down all four buttons on the watch, this will do a factory reset.

Hold down the top left button, which brings you into the configuration mode.

Pressing the bottom left button will cycle you through all the settings for the time. For each setting, the top right button increments and the bottom right decrements.

When you are done, press the top left again.