Ajust carby dolmar 110 - Husqvarna Chain Saw 20" Bar

Ignition Module Coil for Dolmar Maybe for your Country otherwise search by Makita also there are several equvalent parts to get forSachs Dolmar and its cheaper , beware on this to order ignition coils by mention on the serial motor number and the year of build by all orderings if it must be the right combination to get it can be important by marketing technical upgrades / modifications because of changed flywheels in several Dolmar models over past time i know. a suggested coil in a link

air filter bolt to the face of the carby and most carbys are generic make
talk with your local mower , shop and get one that has the bolt holes in the same place or in such a position where you can drill new holes to fit it on

it sounds like your low ideal need ajusting up. it is positiond on the side of the carby. you are looking for some thing that resembals a screw hed. you should be abel to ajust it with a short phileps hed scrow driver.

Which Makita? Check your area for Dolmar dealer. They are the actual manufacturer. You might try these links also.
Dolmar/Makita:
http://www.makita.ca/index2.php?event=toollist&categoryid=7
http://charlotte.preferredpower.com/DOLMAR/Browse.htm
You can still reply below and I will happily assist you. HTH
Lou

Dolmar/Makita
http://charlotte.preferredpower.com/DOLMAR/Browse.htm
The power cuts use Dolmar numbers. I'll wager one of the -7314s is yours. HTH
Lou

on your carb you will find 2 screws 1 is a thritle stop screw the outher is the mixture screw the ajustment y need is the throttle screw hope this helps

Dealer locater
http://www.dolmar.com/

IPLs can be found here:
http://charlotte.preferredpower.com/DOLMAR/Browse.htm

Did you try NAPA? Take your screw with you.

Here is a dealer has always been good to me.
http://www.fastcutting.com/ HTH
Lou

This is a an old saw. I suggest you try here:
ArboristSite.com Chainsaw thread
http://www.arboristsite.com/forumdisplay.php?f=9
I did a search for "Sachs Dolmar Super 133" and got over 10 hits.
Please search the existing posts before asking your question, the answer may have been asked and answered. It is free to join if required. They are a collection of chainsaw enthusiasts and very helpful.
This guy is a Dolmar dealer and dealt with them for many years.
http://www.arboristsite.com/member.php?u=3404
Scott has an operational radial dolmar... pretty cool. GL
Lou

I think this answers your question fully. Please rate my answer.

Sounds like it needs a fuel pump kit, and possibly also a carby kit.

take photos as you are pulling the fuel pump or carby apart, or get a service manual for the outboard. The dealer might photocopy the pages you need if you ask nicely.

bad convergence ic normaly stk392-110