Picture is so light you can't see anything - Samsung Digimax S730 Digital Camera

A clue to the make and model of the device would help.
From your question, it could be anything.

yes if you install a graphic card it will bypass on-board graphic chip.
if you dont have 1 borrow a friends first just to make shore its the problem...........dt

I need some help, no picture, no sound either or what? Also was set doing anything unusual before it failed?

It's a new camera....you shouldn't have to fix anything.....return it immediately.

more than likely you need to replace the lamp. Before you buy anything check the lamp to make sure.

I just changed light bulb and still the red light is no. No sound no picture

You might have a defective lamp, if not then the ballast might be the problem, Julio milleniumtvsvc@gmail

hi..the reason due to this problem may be
due to the circuit board.If the soldering is not
done in any part of the main board this type of
problem occurs.check the board completely.
check this out..
thank u..
rate me..

Dead CCD.
Needs replacement.

the power supply to your picture tubes may be bad