Powers on with lights then lights go off and printer sound then nothing

its the back cover,if its not at lock position,your printer wont com on

First try taking the inks out and the printhead and see if power stays on. If so you need a new printhead. the part number is on the side. If not, sounds like a bad power supply.

IT COULD BE THAT THE INK SERVICE STATION CANNOT MOVE BECAUSE OF WATE INK.ALSO ADD SOME SEWING MACHINE OIL TO THE SILVER SLIDE BAR THAT THE CARIAGE RUNS ON.DONT GET OIL ON ANY OTHER PARTS

Sounds like a partial power supply failure; the output for the motor drive(s) has failed. This may be a separate assembly but some covers may need to be removed to determine this. 

power supply is shot

this sounds like ur both cartridges are empty...

you can buy a new printer

This maybe down to a faulty cartridge replace cartridges and then retry. You can try the following to obtain a test sheet.

• Turn on printer
• Hold power button down (While printer is on)
• Press the paper feed button once
• Release both buttons

This will printout a test sheet but I really do think that it is a faulty cartridge problem.

Hope I could help
Thanks J

5 times try this:
1: Unplug Power Cord

2: Hold POWER and RESUME buttons

3: Plug in Power Cord

4: Release buttons after the printers starts up

5: Hold CARTRIDGE and RESUME

6: Press POWER

7: Release all buttons after the beeps

8: Press CARTRIDGE 16 times

9: Press RESUME

10: Unplug the Power cord
---------------------------------

3 times, probably something wrong with the cartridge.

This solution sounded to strange to be real but I was desperate for a solution to the orange light blinking 7 times and getting NO response from the printer whatsoever. It actually worked!

1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not, press the Power button once more.
8. Your printer should respond as normal.